Bedienungsanleitung HQ Power PROMIX66N (Seite 4 von 38) (Deutsch, Englisch, Holländisch, Französisch, Spanisch, Polnisch)

622642

Zoom out

Zoom in

Vorherige Seite

1/38

Nächste Seite

PROMIX66N/PROMIX88N

V. 01 – 30/10/2012 4 ©Velleman nv

9. LINE IN

Each stereo channel has two balanced line level inputs on 1/4" TRS jacks for left and right channels (tip =

positive (+), ring = negative (-), sleeve = ground). If only the connector marked “L” (left) is used, the channel

operates in mono. The stereo channels are designed to handle typical line level signals. The input signals to

these jacks can be either balanced or unbalanced.

10. BAL Control

For a mono input to the L (MONO) input the function of the control is the same as the PAN controls (6) of the

mono channels. However, when a channel is run in stereo, this control functions as a BALANCE control,

determining the relative balance of the left and right channel signals being sent to the left and right MASTER

MIX buses. For example, with the BALANCE control turned fully clockwise, only the right portion of the

channel’s stereo signal will be routed to the MASTER MIX.

MASTER Section (fig. 3 & 4)

11. STEREO AUX RETURNS (LEFT / MONO, RIGHT)

The AUX RETURN jacks are the mono or stereo returns for AUX SEND. If you connect a signal to the LEFT /

MONO RETURN jack only, the AUX RETURN will operate in mono and the signal will be routed to the AUX

RETURN control (19) and then mixed into the left and right MASTER MIX stereo outputs (13). The separate left

and right return jacks are provided for use with stereo signals such as those from the output of a stereo effects

processor. The left and right return signals will be routed to the AUX RETURN level control (19) and mixed into

the left and right STEREO OUT (13) while maintaining stereo separation.

12. AUX SEND

The AUX SEND is the output for the signal sent from the channel AUX / EFF controls (5) and by the AUX SEND

controls (18) control. They are 1/4" unbalanced phone jacks (tip = positive (+), sleeve = ground). AUX SEND is

a post-fader. These signals can be sent to the input of an effects processor, multi-track recorder, or used for

any other line-level auxiliary purpose.

13. STEREO Outputs

Use these jacks to connect to an external power amplifier if extra output power for a larger PA system is

required. The stereo outputs are left (L) and right (R) unbalanced 1/4" phone jacks, wired as tip = positive (+),

sleeve = ground.

14. TAPE Inputs

These jacks will accept the signal from an external device with a stereo output such as a cassette recorder.

15. REC Outputs

The REC outputs also provide an output of the MASTER MIX. These outputs are RCA jacks and designed

primarily for inputs to tape recorders etc.

16. L-R Control Room Outputs

The L-R control room outputs can be connected to an amp to power stereo control room (or other) monitor

speakers and are 1/4" unbalanced phone jacks, wired as tip = positive (+), sleeve = ground.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

HQ Power PROMIX66N Seite 4

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info