10 English
Doorbell connection
Use the adhesive ring to glue the
microphone to the sound outlet of
your doorbell/intercom system and
plug the microphone cable into the
connection jack on the bottom of the
transmitter. To do this, pull off the bak-
king foil from the adhesive ring on the
microphone.
For optimum function of the transmit-
ter, its sensitivity dial switch must be
set so the transmitter reliably
responds to the doorbell.
Setting the sensitivity
1. Set the sensitivity dial switch to its
lowest level (turn to the anticlock-
wise to stop).
2. Activate the doorbell and gradual-
ly increase the sensitivity of the
transmitter (by turning the dial
clockwise) until the transmitter
reacts to the doorbell.
3. If your intercom system operates
with different signal tones, make
sure that both signal tones are reli-
ably detected.
Important note
All
lisa
devices connected to the
mains supply have a low power con-
sumption which may lead to the devi-
ce feeling warm. This is normal and
does not interfere with the normal
function of the devices.
These signalling systems have a high
operational safety. Should any faults
occur in spite of proper installation
and use, please contact your dealer.
High and low voltage spikes (e.g.
during a thunderstorm) can occur on
the mains supply. The
lisa
devices
have an integrated electronic control-
ler which may stop working after
these conditions. If this happens sim-
ply unplug each of the devices and
plug them in again.
As a precaution remove all de vices
from their sockets during a thun-
derstorm.
The use of halogen lamps or other
equipment (e.g. Micro wave Ovens)
may, in rare cases, interfere with the
lisa
signals. In these cases the use of
mains filters or suppressors is advisa-
ble. Please ask your dealer.
Maintenance and care
All
lisa
devices are maintenance free.
To clean, remove from their mains
sockets and wipe over with a moiste-
ned cloth. Never use alcohol, thinner
or other organic materials.
lisa
devices should not be exposed to
excessive direct sunlight, heat, thick
dust, humidity or mechanical shock.
Note: This product is not protected
against splash water. Do not place
any container s filled with wa ter, such
as flower vases, or anything with an
open flame, such as a lit candle, on or
near the product.
TuerAK_kl_lisa_1008:BA_TuerAK_kl_lisa_0307 08.10.2008 11:40 Se
