Bedienungsanleitung Humminbird 325 (Seite 65 von 68) (Englisch)

522308

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

SONAR (SOund and NAvigation Ranging) Sonar technology uses precision sound

bursts transmitted underwater to determine the distance and other attributes of objects in

the water. Distance can be determined because the speed of sound in water is constant,

and the time for the signal to return is measured. Sound also travels very quickly

underwater, making sonar a responsive, cost-effective tool. Sonar is the basic technology

behind all recreational and commercial fishfinding and depthfinding devices.

Sonar Update Rate The number of times per second that the transducer’s

transmitter/receiver sends and receives sonar signals. A very fast sonar update rate collects

more information and provides a more detailed image of the bottom, fish, and structure.

Many Humminbird® units operate at up to 40 times per second when in single frequency

operation. Due to the limitation of the speed of sound in water, the update rate begins to

slow as depth increases to deeper than 50 feet. In very shallow water (less than 10 feet),

however, update rates as much as 60 times per second can be achieved.

Speed The rate at which the boat moves through the water. Boat speed can be measured

as Speed Over Ground or Speed Through Water. Speed Over Ground is provided by GPS, and

is the measurement of the boats progress across a given distance. Speed Through Water is

provided by a speed paddlewheel, and is the measurement of the flow past the boat, which

may vary depending on current speed and direction. Speed Through Water is most critical

for anglers using downriggers, as it impacts the running depth of the down riggers. Speed

Over Ground is optimal for navigation, as accurate destination times can be derived from

this measurement. Humminbird® products allow for input and display of both sources.

Structure A general term for objects on the bottom that present a discontinuity and are

a likely attractor for fish. This includes bottom contour features (drop-offs, humps, and

holes), standing structure (stumps, timbers, brush piles), and a wide range of other

potential objects (sunken boats, reefs).

Surface Clutter A phenomenon where sonar returns are reflected off of tiny objects near

the surface of the water, including algae and even air bubbles. Typically, saltwater

environments have significantly greater surface clutter than freshwater due to continuous

wind and wave action that causes aeration at the surface.

Target Separation The measurement of minimum distance that a fishfinder needs to be

able to recognize two very close objects as two distinct targets (i.e. two fish hanging very

close, or a fish hanging very close to structure). Humminbird® fishfinders provide a very

good 2 1/2 inches of target separation in shallower than 100 feet of depth. Target

separation decreases as depth increases due to the need for longer Pulse Width to achieve

greater depth. See

Pulse Width.

Glossary

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Humminbird 325 Seite 65

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info