1. Ensure the motor stops completely and unplug the power cord.
2. Hold the juice outlet and the hopper with both hands and lift them up from the base.
When unplugging the power cord, hold the head part of the power cord and unplug it.
Do not touch the power cord with wet hands.
Always wash the chamber set immediately after each use. Without wash-up, remained pulps get dried up and stuck onto it. It makes
difficult to disassemble or wash them. Also, it may cause degradation in performance.
3. Disassemble the parts in reverse as below:
1) Unlock the chamber twisting to counterclockwise.
2) Take the auger out.
3) Remove the strainer.
4) Take the spinning brush out and disassemble the silicone brush.
4. Rinse each parts with cleaning brush and brush the inside and outside under running water.
Never use scouring pads, abrasive cleaning agent, aggressive liquids or sharp cleaning tools.
Do not wash them in a dishwasher or a dish dryer.
5. Wipe the stain on the base with soft damp cloth or wrung towel and dry it thoroughly.
Do not immerse the base unit in water or any other liquid, nor rinse it under tap.
6. After each cleaning, allow them to air-dry completely and store them in a clean and safe place.
www.hurom.com l 15
DISASSEMbLY, CLEANING AND CARE
4 5
HG-2 4PJ12249_V.01.indd 17 2013-08-14 오후 1:50:22
