Bedienungsanleitung Husqvarna 420EL (Seite 105 von 606) (Alle Sprachen)

734169

105

Zoom out

Zoom in

Vorherige Seite

1/606

Nächste Seite

GENERAL SAFETY PRECAUTIONS

English – 105

Electrical safety

• It is recommended that you use a Residual Current

Device (RCD) with a tripping current of not more than

30mA. Even with a RCD installed 100% safety cannot

be guaranteed and safe working practice must be

followed at all times. Check your RCD every time you

use it.

• Before use, examine the cable for signs of damage or

ageing. If the cable is found to be defective, take the

product to an Authorized Service Center and have the

cable replaced.

• Do not use the product if the electric cables are

damaged or worn.

• Immediately disconnect from the mains electricity

supply if the cable is cut, or the insulation is damaged.

Do not touch the electric cable until the electrical

supply has been disconnected. Do not repair a cut or

damaged cable. Take the product to an Authorised

Service Centre and have the cable replaced with a

genuine spare cable.

• Always make sure that the cable/extension cord is

kept behind the user, ensuring that it does not create

a source of danger for the user or for other persons,

and check that it cannot be damaged (by heat, sharp

objects, sharp edges, oil, etc);

• Position the cable so that it will not be caught on

branches and the like, during cutting.

• Always switch off at the mains before disconnecting

any plug, cable connector or extension cable.

• Switch off, remove plug from the mains and examine

electric cable for damage or ageing before winding

cable for storage. Do not repair a damaged cable.

Take the product to an Authorised Service Centre and

have the cable replaced.

• Remove the plug from the mains before leaving the

product unattended for any period.

• Always wind cable carefully, avoiding kinking.

• Use only on AC mains voltage shown on the product

rating label.

• The chainsaw is double insulated to EN60745-1 & 2-

13.

•Make sure your extension cord is in good

condition. Inspect extension cord before use and

replace if damaged. Do not use a damaged cord.

Cord insulation must be intact with no cracks or

deterioration. Plug connectors must be undamaged.

Damaged extension cords increase the risk of electric

shock.

•Residual Current Device (RCD) protection should

be provided on circuit or outlet to be used.

Receptacles are available having built-in RCD

protection and may be used for this measure of safety.

Inspect chain saw cords periodically and if damaged,

have repaired by an authorized service dealer.

Cables

• Extension cables are available from your local

Approved Service Centre.

• Only use approved extension cables.

• Extension cables and leads should only be used if

they are designed for outdoor use and comply with

H07 RN-F or IEC 60245 designation 66.

Before using a new chain saw

• Please read this manual carefully.

• Fill with chain oil. See instructions under the heading

Filling with chain oil.

• Do not use the chain saw until sufﬁcient chain oil has

reached the chain. See instructions under the

heading Lubricating cutting equipment.

• Check that the cutting equipment is correctly ﬁtted

and adjusted. See instructions under the heading

Assembly.

• Long-term exposure to noise can result in permanent

hearing impairment. So always use approved hearing

protection.

• This saw is intended for use between the

temperatures of -20°C (-4°F) and +40°C (104°F).

WARNING! Under no circumstances may

the design of the machine be modiﬁed

without the permission of the

manufacturer. Always use original

accessories. Non-authorized

modiﬁcations and/or accessories can

result in serious personal injury or the

death of the operator or others.

WARNING! A chain saw is a dangerous

tool if used carelessly or incorrectly and

can cause serious, even fatal injuries. It

is very important that you read and

understand the contents of this

operator’s manual.

WARNING! This machine produces an

electromagnetic ﬁeld during operation.

This ﬁeld may under some

circumstances interfere with active or

passive medical implants. To reduce the

risk of serious or fatal injury, we

recommend persons with medical

implants to consult their physician and

the medical implant manufacturer before

operating this machine.

WARNING! Long term inhalation of chain

oil mist and dust from sawdust can

represent a health risk.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna 420EL Seite 105

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info