7 Transportation, storage and disposal
7.1 Transportation
The supplied Li-ion batteries obey the Dangerous Goods
Legislation requirements.
• Obey all applicable national regulations.
• Obey the special requirement on package and
labels for commercial transportations, including by
third parties and forwarding agents.
7.2 Storage
• Fully charge the product. Refer to
To charge the
battery on page 32
.
• Switch off the product. Refer to
To set the product
to OFF on page 32
.
• Clean the product. Refer to
Clean the product on
page 33
.
• Keep the product in a dry, frost free space.
• Keep the product with all wheels on level ground
during storage, or use a wall hanger.
• If you keep the charging station indoors,
disconnect and remove the power supply and
all the connectors from the charging station. Put
the end of each connector wire in a connector
protection box.
Note: If you keep the charging station outdoors,
do not disconnect the power supply and the
connectors.
• Contact Husqvarna sales representative about
what accessories are available for your product.
7.3 Disposal
• Obey the local recycling requirements and
applicable regulations.
• For questions about how to remove the battery,
refer to
To remove the battery on page 47
.
7.3.1 To remove the battery
CAUTION: Only remove the battery
when you dispose the product. When you
remove the warranty seal, the Husqvarna
warranty is no longer applicable.
1. Remove the top cover and the body of the product.
Follow steps 1-7 in
To clean the chassis and blade
disc on page 33
.
2. Remove the 12 screws with a Torx 20.
3. Lift the rear edge of the top section of the chassis.
4. Disconnect the cable from the main circuit board.
5. Remove the top section of the chassis.
6. Remove the 2 screws that holds the battery with a
Torx 20.
7. Push to detach the clips and lift up the battery
holder.
8. Disconnect the battery cable from the main circuit
board.
1650 - 005 - 17.03.2022 Transportation, storage and
disposal - 47
