• Combination pliers: For cutting the boundary
wire and pressing the connectors together.
• Adjustable plier: For pressing the couplers
together.
• Edge cutter/straight spade: To bury the
boundary wire.
3.5.2 To install the charging station
WARNING: Obey national regulations
about electrical safety.
WARNING: The product is only to be
used with the power supply unit
supplied by Husqvarna.
WARNING: Do not put the power
supply at a height where there is a risk
it can be put in water. Do not put the
power supply on the ground.
WARNING: Do not encapsulate the
power supply. Condensed water can
harm the power supply and increase
the risk of electrical shock.
WARNING: Risk of Electric Shock.
Install only to an earth fault breaker
(RCD) when connecting the power
supply to the wall socket. Applicable to
USA/Canada. If power supply is
installed outdoors: Risk of Electric
Shock. Install only to a covered Class
A GFCI receptacle (RCD) that has an
enclosure that is weatherproof with the
attachment plug cap inserted or
removed.
CAUTION: Do not make new holes in
the charging station plate.
CAUTION: Do not put your feet on the
baseplate of the charging station.
CAUTION: The power supply cable
and extension cable must be outside
the work area to avoid damage to the
cables.
When connecting the power supply, only use a
wall socket that is connected to an earth fault-
breaker (RCD).
1. Read and understand the instructions about
the charging station. Refer to
To examine
where to put the charging station on page
20
.
2. Put the charging station in the selected area.
Note: Do not attach the screws for the
charging station to the ground until the guide
wire is installed. Refer to
To install the guide
wire on page 27
.
3. Connect the low-voltage cable to the
charging station.
4. Put the power supply at a minimum height of
30 cm / 12 in.
5. Connect the power supply cable to a
100-240V power outlet.
Note:
When the charging station is
connected, it is possible to charge the
product. Place the product in the charging
station while the boundary and guide wires
are being laid. Switch on the product. Refer
to
To switch on the product on page 37
. Do
not continue with any product settings
before the installation is complete.
6. Put the low-voltage cable in the ground with
stakes or bury the cable. Refer to
To put the
wire into position with stakes on page 28
or
To bury the boundary wire or the guide wire
on page 28
.
7. Connect the wires to the charging station
after the installation of boundary wire and
26
- Installation
1404 - 001 -
