Bedienungsanleitung Husqvarna AUTOMOWER 440 (Seite 25 von 100) (Englisch)

684092

Zoom out

Zoom in

Vorherige Seite

1/100

Nächste Seite

0 cm/0"

3012-1073

0 cm/0"

3012-686

3012-1064

3012-563

English - 23

INSTALLATION

Boundaries Within the Working Area

Use the boundary wire to demarcate areas inside the

working area by creating islands around obstacles which

can not withstand a collision, for example 

bushes and fountains. Lay the wire up to and around

the area to be demarcated, and then return it back along

the same route. If pegs are used, the wire should be

laid under the same peg on the return route. When the

boundary wires to and from the island are laid close

together, the robotic lawnmower can drive over the wire.

IMPORTANT INFORMATION

The boundary wire may not be crossed on

its way to and from an island.

Obstacles that can withstand a collision, for example

trees and bushes higher than 15 cm, do not need to be

demarcated by the boundary wire. The robotic lawnmower

will turn when it collides with this type of obstacle.



around the working area. This results in the most gentle

and silent operation and prevent the robotic lawnmower



Obstacles that slope slightly, for example stones or large

trees with raised roots, must be isolated or removed.

Otherwise the robotic lawnmower can slide up onto this

kind of obstacle causing the blades to be damaged.

Secondary Areas

If the working area consists of two areas which the



recommended to set up a secondary area. Instances of

this are 45 % slopes or a passage that is narrower than

60 cm. Then lay the boundary wire around the secondary

area so that it forms an island outside the main area.

The robotic lawnmower must be moved manually between

the main and secondary area when the lawn in the

secondary area has to be cut. Since the robotic lawnmower

is not able to get to the charging station by itself from a

secondary area, Secondary area (A) operating mode must

be used,

see 5.1 Operating Mode Start on page 38.

The robotic lawnmower will then not start searching for the

charging station but use its entire capacity to mow. When



Needs manual charging message will appear in the display.

Then place the robotic lawnmower in the charging station

to charge the battery. If the main area is to be cut straight

after charging, the START button must be pressed and the

Main area (A) selected before closing the hatch.

1157866-26,420,430X,450X,EN_160314.indd 23 2016-03-15 16:13:02

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna AUTOMOWER 440 Seite 25

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna AUTOMOWER 440

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info