518049
26
Zoom out
Zoom in
Vorherige Seite
1/52
Nächste Seite
Instruction book Freesia 415, 425
26
1. Mark the fabric where the button
is to be located.
2. Select zigzag .
3. Lower the feed teeth, see
page15.
4. Snap off the presser foot.
5. Place the material under the
presser foot ankle.
6. Place the button on marking and
lower the presser bar so that the
presser foot ankle is between the
holes of the button (see picture).
7. Hold the thread ends to one
side. Check to be sure that the
needle goes into the left hole of
the button.
8. Touch the mirroring button to
check that the needle also goes
into the right hole.
9. Sew as many stitches as you
consider necessary.
10.Touch STOP. The machine will
then tie off in one of the holes
and stop.
11.Touch STOP to cancel it. Move
to the next pair of holes or the
next button.
If you have a button with a different
hole spacing, you can adjust this by
presssing one of the stitch width
buttons (+) or (-).
Button with a thread shank
Use the hin end of the clearance
plate when sewing buttons on light
fabrics, the thick end for heavier
fabrics.
Place the plate between the button
and the fabric and sew on the
button. Pull the thread ends between
the button and the fabric. Wind the
threads a few times around the
shank and tie the ends.
Sewing buttons
26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Husqvarna Fresia 415 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info