733912
13
Zoom out
Zoom in
Vorherige Seite
1/468
Nächste Seite
Only do the maintenance work
written in this operator's
manual. More extensive work
must be done by an approved
service agent.
Put on heavy duty gloves
when you use the cutting
equipment. The blade is very
sharp and cuts can easily
occur.
Keep the cutting edges sharp
and clean for the best and
safest performance.
Let your service agent
regularly examine the product
and make necessary
adjustments and repairs.
Replace damaged, worn or
broken parts.
Obey the instructions for how
to change accessories. Only
use accessories from the
manufacturer.
When not in operation, keep
the product, battery and
battery charger apart in a dry,
indoor and locked area. Make
sure that children and persons
that are not approved cannot
get access to the product,
battery or battery charger.
Assembly
Introduction
WARNING: Before you assemble the
product, read the safety chapter.
WARNING: To prevent accidental start
during assembly, turn the safety key to 0,
remove the battery and wait at minimum 5
seconds.
To assemble the handle
CAUTION: Do not twist the cables.
1. Align the holes in the upper handle with the holes in
the lower handle.
2. Tighten the knobs on right and left sides fully and
fold the handle up. (Fig. 18)
3. Put the stay in the groove on the cutting cover. (Fig.
19)
4. Attach the 2 stops that lock the stay and the handle.
Push them fully into position. (Fig. 20)
Note: There are 2 stops, one identified with an H
and one with a V. Put the stop with an H on the right
side and the stop with a V on the left side.
CAUTION: Do not operate the product if
the 2 stops are not attached.
Operation
Introduction
WARNING: Before you operate the product,
you must read and understand the safety
chapter.
Husqvarna Connect
Husqvarna Connect is a free app for your mobile device.
The Husqvarna Connect app gives extended functions
for your Husqvarna product:
Extended product information.
901 - 003 - 25.10.2018 13
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

husqvarna-lb-146i

Suche zurücksetzen

  • Es erscheint im Display ein rotes Dreieck mit Ausrufezeichen. Der Mulcher läuft nicht mehr an
    Eingereicht am 13-7-2024 10:23

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Husqvarna LB 146i wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info