Bedienungsanleitung Husqvarna LC 140S (Seite 26 von 92) (Deutsch, Englisch, Französisch, Italienisch, Schwedisch)

595370

Zoom out

Zoom in

Vorherige Seite

1/92

Nächste Seite

OPERATING

26 – English

Work area safety

• Branches, twigs, stones, etc. should be removed from

the lawn before you start to mow.

• Objects hitting against the cutting attachment could

be thrown and cause damage to people and objects.

Keep people and animals well away.

• Never use the machine in bad weather, for instance in

fog, in rain, damp or in wet locations,strong winds,

intense cold, risk of lightning, etc. Working in bad

weather is tiring and can lead to dangerous

conditions, e.g. slippery surfaces.

• Observe your surroundings to ensure that nothing can

affect your control of the machine.

• Beware of roots, stones, twigs, pits, ditches etc. Tall

grass can hide obstacles.

• Mowing slopes can be dangerous. Do not use the

lawn mower on very steep slopes. The lawn mower

should not be used on inclines greater than 15

degrees.

• On sloping ground you should work along the slope. It

is much easier to work along a slope than it is to work

up and down it.

• Be careful when you are approaching hidden corners

and objects that could block your view.

Work safety

• A lawn mower is only designed to mow lawns. All

other use is forbidden.

• Wear personal protective equipment. See instructions

under the ”Personal protective equipment” heading.

• Do not start a lawn mower unless the cutter and all

covers are ﬁtted correctly. Otherwise the cutter could

come loose and cause personal injuries.

• Make sure the cutter does not hit foreign objects such

as stones, roots or the like. This can make the cutter

dull and bend the engine shaft. A bent axle gives

imbalance and heavy vibration, which results in a

great risk of the cutter becoming loose.

• The brake handle must never be permanently

anchored in handle when the machine is running.

• Place the lawn mower on ﬁrm, ﬂat surface and start it.

Make sure that the cutter cannot come into contact

with the ground or other objects.

• Always place yourself behind the machine. Allow all

the wheels to remain on the ground and keep both

hands on the handle when mowing. Keep your hands

and feet away from the rotating blades.

• Never use the machine if the grass catcher or the rear

deﬂector is not mounted.

• Do not tilt the machine when the engine is running.

Never run with the machine when it is running. You

should always walk with the lawn mower.

• Pay particular attention when pulling the machine

towards you during work.

• Never lift up the lawn mower or carry it around when

the engine is running. If you must lift the lawn mower,

ﬁrst switch off the engine and disconnect the ignition

lead from the spark plug.

• Do not mow the lawn while walking backwards.

• The engine should be switched off when moving over

ground that is not to be mowed. For example, gravel

paths, stone, shingle, asphalt, etc.

• Never run with the machine when it is running. You

should always walk with the lawn mower.

• Shut down the engine before changing the cutting

height. Never make adjustments with the engine

running.

• Never leave the machine unsupervised with the motor

running. Turn off the motor. Ensure the cutting

attachment has stopped rotating.

• If any foreign object is hit or if vibrations occur stop the

machine immediately. Disconnect the HT lead from

the spark plug. Check that the machine is not

damaged. Repair any damage.

Basic working techniques

• Always cut with a sharp blade for optimal results. A

dull blade gives an uneven cut and the grass becomes

yellow on the surface of the cut.

• Never mow more than 1/3 of the length of the grass.

This especially applies during dry periods. Mow ﬁrst

with the cutting height set high. Then check the result

and lower to an appropriate height. If the grass is

really long, drive slowly and mow twice if necessary.

• Cut in different directions each time in order to avoid

stripes in the lawn.

• Before pulling the machine towards you, disengage

the drive and push the machine forward approx. 10

cm.

• Make sure to disengage the drive when approaching

an obstacle.

Transport and storage

• Secure the equipment during transportation in order

to avoid transport damage and accidents.

• Store the equipment in a lockable area so that it is out

of reach of children and unauthorized persons.

• Store the machine and its equipment in a dry and frost

proof place.

• For transport and storage of fuel, see the section

"Fuel handling".

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna LC 140S Seite 26

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna LC 140S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info