Bedienungsanleitung Husqvarna LC 451S (Seite 11 von 352) (Alle Sprachen)

733935

Zoom out

Zoom in

Vorherige Seite

1/352

Nächste Seite

injury or death. Do not change the product. Always

use accessories that are approved by the

manufacturer.

• If the maintenance is not done correctly and

regularly, the risk of injury and damage to the

product increases.

• Only do the maintenance as given in this owner's

manual. All other servicing must be done by an

approved Husqvarna service agent.

• Let an approved Husqvarna service agent do

servicing on the product regularly.

• Replace damaged, worn or broken parts.

Assembly

Introduction

WARNING: Before you assemble the

product, you must read and understand the

safety chapter.

WARNING: Remove the spark plug cable

from the spark plug before you assemble the

product.

To assemble the handle

1. Loosen the lower knobs on the left and the right side

of the product. Make sure that the plastic washer is

in the recess in the handle bracket. (Fig. 29)

2. Install the handle folded forward as shown in the

illustration. (Fig. 30)

a) Make sure that the plastic washer is between the

handle and the handle bracket.

b) Attach the handle to the handle bracket.

3. Lift the handle up. (Fig. 31)

4. Tighten the knobs fully. To adjust the handle height,

refer to

To adjust the handle height on page 11

5. Put the wires in the cable brackets. Make sure that

the wires are not twisted. Attach the cable brackets

to the handle. (Fig. 32)

6. Use a cable tie to attach the cables to the handle

bracket. (Fig. 33)

To adjust the handle height

1. Loosen the lower knobs.

2. Move the knobs to the lower end of the grooves on

the left and the right side of the product. (Fig. 34)

3. Set the handle height in 1 of the 2 available

positions.

4. Move the knobs up in the direction of the handlebar

until they stop and you hear a click. (Fig. 35)

5. Tighten the knobs fully.

To set the product in transport position

1. Remove the grass catcher.

2. Loosen the lower knobs.

3. Move the knobs to the lower end of the grooves on

the left and the right side of the product. (Fig. 34)

4. Fold the handle forward. (Fig. 36)

To set the product in operation position

1. Lift the handlebar up. (Fig. 31)

2. Move the knobs up in the direction of the handlebar

until they stop and you hear a click. (Fig. 35)

3. Tighten the knobs fully.

To assemble the grass catcher

1. Attach the grass catcher frame to the grass bag with

the rigid part of the bag on the bottom. Keep the

handle of the frame on top of the grass bag. (Fig. 37)

2. Attach the bottom of the grass catcher frame to the

bottom of the grass bag. (Fig. 38)

a) Push the grass catcher frame into the groove.

Start at the right side as shown in the illustration

and move gradually to the left.

3. If the grass catcher frame is not easy to attach, hit

the grass catcher frame carefully with a rubber

mallet. Hit the grass catcher frame between the

reinforcements. (Fig. 39)

4. Attach the grass bag to the grass catcher frame with

the clips. (Fig. 40)

5. Lift the rear cover.

6. Attach the grass catcher to the top edge of the

chassis.

7. Put the lower part of the grass catcher into the grass

discharge channel. (Fig. 41)

To assemble the mulch plug

(accessory)

1. Lift up the rear cover and remove the grass catcher.

2. Put the mulch plug into the discharge channel. (Fig.

42)

3. Replace the blade with the mulch blade that is

supplied with the mulch kit. Refer to

To replace the

blade on page 14

To cut grass without a grass catcher or

mulch plug attached

• Lift up the rear cover and remove the grass catcher.

• If a mulch plug and a mulch blade are attached,

remove them.

• Close the rear cover before you operate the product.

When you operate the product, the cut grass discharges

below the rear cover.

929 - 002 -

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna LC 451S Seite 11

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info