Bedienungsanleitung Husqvarna R147 S (Seite 7 von 132) (Alle Sprachen)

474788

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

ENGLISH -

OPERATION

ENGINE ADJUSTMENTS (Fig.JI)

Refer to the engine manufacturer’s maintenance ma-

nual.

CAUTION:- 0.6l Oil must be added to the

engine before use

STARTING THE ENGINE (Fig.J

II)

Once the machine has been set up properly, start the

engine as follows:

a) Engines with choke system:

when

the engine is cold, position the accelerator lever

(13) on START

b)Operate the engine stop lever (14) to prepare the

engine for start, keep lever pressed against handle

while starting and using the machine (it operates the

engine brake).

c) Engines with primer system:

Press

the fuel-enrichment pump (2) located on the car-

burettor 3 or 4 times position the accelerator lever (13)

on MAX.

For further information and explanations, read carefully

the user instruction manual of the engine.

d) Start engine.

MANUAL

STARTING: (While holding the engine stop

lever (14)).



Hold the engine start-grip (11) and pull the starter rope

gently until you feel the resistance caused by compres-

sion. Return the starter rope slowly then pull the handle

rmly towards you to its full extent.

ELECTRICAL STARTING: (While holding the engine

stop lever (14)).



Insert the plug (G) in the socket (H) on the engine.

Turn the ignition key (16).

CAUTION: The blade starts turning as soon

as the engine is started.

Keep the engine stop lever (14) depressed during machine

operation. When the lever is released, the engine stops.

MOWING

To cut the grass, push the lawn mower manually or insert

the automatic advance gear.

How to insert automatic advance (Fig. J

III): Lift up the

clutch handle (17 - 18) and keep it pressed in position.

CAUTION: Engage the gear only when the

engine is running.

How to disengage advance: Release the clutch han-

dle.

ADJUSTMENT OF CLUTCH CABLE (for self-propelled versions only)

Important: If, when you press the clutch lever, the automatic advance gear does not engage, the clutch cable should

be adjusted by inserting the spring (P) in one of the subsequent holes in the plate (R) or in the hole “S” .

MAINTENANCE

Caution! Switch off the motor and disconnect

the spark plug before undertaking any mainte-

nance work.

 The lawn mower must be checked by a SERVICE

DEALER.

 Cleaning under the bodywork

With machine at a standstill and off.

- Attach tting (22) on the deck to the water supply tap.

Turn on the tap.

- start up the motor (blade in rotation), allowing it to

warm up for a few minutes.

- at the end of cleaning switch off the motor, turn off the

tap, detach the tube from the deck connection.

 For a four stroke engine, check the oil level and change

the oil when dirty. For further explanation, see ENGINE

INSTRUCTION BOOK.

 Frequently check the mower and ensure that all grass

deposits are removed from beneath the deck.

 Never clean the mower by pouring water over it: this may

seriously damage the electric start system.

 Take care, the exhaust mufer may be very hot.

 Frequently check the blade for damage.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna R147 S Seite 7

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna R147 S

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info