Bedienungsanleitung Husqvarna Rider 216 (Seite 28 von 132) (Englisch, Italienisch, Portugiesisch, Spanisch)

467966

Zoom out

Zoom in

Vorherige Seite

1/132

Nächste Seite

2. Attach the tension belts around the frame or rear

wagon.

3. Tighten the tension belts in the direction of the rear

and the front of the trailer to secure the product.

4. Put the wheel blocks in front of and behind the rear

wheels.

To tow the product

The product has a hydrostatic transmission. To prevent

damage to the transmission, tow the product short

distances only and at low speed.

Disengage the transmission before you tow the product.

Refer to

To engage and disengage the drive system on

page 12

Storage

Prepare the product for storage at the end of the

season, and before more than 30 days of storage. If you

keep fuel in the fuel tank for 30 days or more, tacky

particles can cause blockage in the carburetor. This has

a negative effect on the engine function.

To prevent tacky particles during storage, add a

stabilizer. If alkylate gasoline is used, stabilizer is not

necessary. If you use standard gasoline, do not change

to alkylate gasoline. This can cause sensitive rubber

parts to become hard. Add stabilizer to the fuel in the

tank or in the container used for storage. Always use the

mixing ratios given by the manufacturer. Run the engine

for a minimum of 10 minutes after you add the stabilizer

until it flows into the carburetor.

WARNING:

Do not keep the product with

fuel in the tank in an indoor location or in

locations with bad airflow. Risk of fire if fuel

fumes come near open flames, sparks, or

pilot lights in for example boilers, hot water

tanks and clothes dryers.

WARNING: Remove grass, leaves and

other flammable materials from the product

to decrease the risk of fire. Let the product

become cool before you put it in storage.

• Clean the product, see

To clean the product on page

. Repair paint damages to prevent corrosion.

• Examine the product for worn or damaged parts and

tighten loose screws and nuts.

• Remove the battery. Clean it, charge it, and keep it

cool during storage.

• Change the engine oil, and discard the waste oil.

• Empty the fuel tank. Start the engine and run it until

there is no remaining fuel in the carburetor.

Note:

Do not empty the fuel tank and carburetor if a

stabilizer has been added.

• Remove the plugs and put about a tablespoon of

engine oil into each cylinder. Manually turn the

engine shaft to apply the oil and put the plugs back

on.

• Lubricate all grease nipples, joints and axles.

• Keep the product in a clean and dry area and cover

it for more protection.

• A cover for protection of your product during storage

or transport is available at your dealer.

Disposal

• Chemicals can be dangerous and must not be

discarded on the ground. Always discard used

chemicals at a service center or an applicable

disposal location.

• When the product is worn out, send it to the dealer

or to an applicable recycling location.

• Oil, oil filters, fuel and the battery can have negative

effects on the environment. Obey the local recycling

requirements and applicable regulations.

• Do not discard the battery as domestic waste.

• Send the battery to a Husqvarna service agent or

discard it at a disposal location for used batteries.

28 854 - 003 - 14.11.2018

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Husqvarna Rider 216 Seite 28

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Husqvarna Rider 216

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info