518159
57
Zoom out
Zoom in
Vorherige Seite
1/64
Nächste Seite
Instruction book Rose
57
Incorrect stitch
If the machine does not sew the
stitch indicated by the display, it is
possible that the electronics have
been disturbed in some way, per-
haps by a short power cut or electri-
cal disturbance. Shut off the main
switch, wait a few seconds and try
again. If the fault remains, contact
your dealer.
The stitch is too loose - fabric
layers not held together
The thread tension is far too loose.
Page 14 shows how to adjust the
thread tension.
Fault-finding
Machine runs sluggishly
Dirt or lint has built up under the
stitch plate. Loosen the plate and
brush clean between the feed teeth
and in the bottom area. See page 55.
Balance setting for buttonhole
Balance can only be set if a button-
hole is selected. Press the buttons
and until the letters BAL
are flashing to the left on the dis-
play. In place of the stitch length
indication a balance indication is
shown. When you wish to increase
the density of the right column,
press stitch length button (-). When
you wish to decrease the density,
press stitch length button (+). The
balance can be set between -5 to +5.
The balance indication on the dis-
play will change in steps fo each
touch. When you select another
stitch, the display goes back to show
the sitch length indication. The
machine always retains the last
made balance setting.
Main motor does not work
The electronic overload protector
may have switched off. Shut off the
main switch, wait about a minute.
Then switch on the machine.
The sewing and embroidery
machine screen does not respond
to touch
The socket on the back of the
machine where the embroidery unit
is connected can be sensitive to
static electricity when the
embroidery unit is not connected. If
the sewing machine screen does not
respond to touch, turn the machine
off and back on again. If this
persists, contact your authorized
Husqvarna Viking retailer.
Expert assistance
Have your machine "tuned up"
regularly by your dealer. If you have
followed the preceding points and
still do not get satisfactory results,
you should contact the dealer where
you bought the machine. When the
machine is being checked, it is a
great help if it can be test sewn
under as similar conditions as
possible as when you used it.
Remember to take a sewing sample
along with you, preferably of the
fabric and with the thread you
intend to use.
A sewing sample will often give
much better information than words.
Non-original Parts and
Accessories
The warranty does not cover any
defect or damage caused by use of
non-original accessories or parts.
Fault-finding
57

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln
1

Forum

husqvarna-rose-605

Suche zurücksetzen

  • Ich suche dringend o.a. Betriebsanleitung für die Husqvarna ROSE Nähmaschine in d e u t s c h Wo bekomme ich
    diese? Bitte um Auskunft, danke im voraus! Mfg H.Kurz Eingereicht am 6-8-2018 16:31

    Antworten Frage melden

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Husqvarna Rose 605 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info