Bedienungsanleitung Hwam 2600 series (Seite 16 von 20) (Englisch)

744525

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Page 15 of 20 pages Page 16 of 20 pages

maIntenance

Cleaning

Any maintenance of the stove should only be carried out when it is cold. Daily maintenance is limited to

vacuum cleaning the stove externally, using the soft brush attachment. You can also dust the stove using a

dry, soft cloth or brush. But remember, only when the stove is cold. Do not use water, spirit or any other

kind of cleaner, as this will damage the lacquer.

Once a year, the stove should be thoroughly serviced. The combustion chamber should be cleared of ashes

and soot. The hinges and the closing hook must be greased with liquid copper fat spray (heat-resistant up to

1100 degrees Celsius), see drawing H. Lift the door approx. ½ cm and spray copper fat onto the hinge leaf.

Service inspection

Your stove should be given a thorough, preventive inspection once every two years. This includes:

• Thorough cleaning of the stove

• Check the spring in the HWAM

Autopilot™ and replace if necessary

• Checking gaskets. Replace gaskets if they are not intact or have softened

• Checking of heat insulating material and possibly replacement

• Lubricating the hinges and the locking hook with cobber grease (drawing H)

All service checks must be performed by an authorised ﬁtter. Use only original spare parts

Inside cleaning

Before chimney sweeping can be performed, the air control knob must be set to its minimum position to

prevent soot and ash from entering the HWAM

Autopilot™. Unless the safety ﬁttings for transportation

have not already been removed, the safety ﬁttings for transportation is bent downwards/forwards until it

is vertical (drawing B, 6a).

The smoke shelf and bafﬂe plate is to be removed from the stove before cleaning

(drawing E)

• Lift the smoke shelf (1) up and a little forward, so it is detached from the uppermost rear plate (2). The

smoke shelf can now be lowered and removed.

• Lift the bafﬂe plate (3) up a little and move it forward until it is detached from the hooks in each side.

After sweeping, reinstall the parts in the stove in reverse order.

Ashes

The ash pan is best emptied by pulling a waste bag over the pan, tipping it and then carefully pulling it out

of the bag. Ashes are disposed of via the domestic waste collection.

Please note that there may be embers in the ashes for up to 24 hours after the ﬁre has

gone out!

Insulation

The efﬁcient, but porous insulation of the combustion chamber may, in time, be worn and damaged. Cracks

in the insulation are irrelevant to the efﬁciency of the stove. However, it should be replaced, if there are

actual holes due to parts of the lining falling off or when, due to wear and tear, it has been reduced to

less than half its original thickness.

HWAM Autopilot

(Drawing F)

Lift off the rear panel. On a cold stove, the starting point of the feeler is controlled. The starting point of

the feeler when the stove is cold is approx. 20° below horizontal level, pointing to the left (by the grove

in the oval steel plate).It should feel easy going and bouncy when you push it, no matter if the stove is

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 2600 series Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 2600 series

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info