Bedienungsanleitung Hwam 2630 (Seite 15 von 36) (Englisch, Italienisch)

571924

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

common spruce to produce the same amount of heat that you would get from a cubic metre of beech.

Banned fuel types

It is not allowed to stoke a ﬁre with the following: printed matter, plywood, plastic, rubber, ﬂuid fuels,

and rubbish such as milk cartons, lacquered wood or impregnated wood and fossil fuels. The reason that

you should not apply any of the above is that during combustion they develop substances that are health

hazardous and harmful to the environment. These substances could also damage your wood burning stove

and chimney, rendering the product warranty void.

Storage of wood

The wood’s water content of a maximum of 20% is reached by storing the wood for a minimum of one

year, preferably outdoors in an open shed exposed to sun and wind.

The wood must be dry (max. 20% water contents) before it is stored indoors. It is recommended that

kindling wood is stored indoors for a couple of days prior to use.

Recommended dimensions

The dimensions of the fuel are important to good combustion. The dimensions should be as follows:

Fuel type Length in cm Diameter in cm

Wood for kindling a ﬁre (ﬁnely chopped) 16-25 2-5

Chopped wood 16-25 7-9

Lighting Up

A successful combustion process requires that the wood is lit in the right way. A cold stove and a cold

chimney challenge the combustion process. It is important to achieve a high ﬂue gas temperature quickly.

Only at temperatures around 350° C will environmentally friendly combustion take place.

Place two pieces of wood (5-8 cm in diameter) horizontally in the bottom of the

combustion compartment. Place 5-8 pieces of kindling randomly on top. Place

two ﬁre-lighters in between the top layers of kindling. Press the remote control

twice to activate the symbol of lighting up. Light up the ﬁre-lighters and close the

stove door. Adjust the temperature selection mechanism on the remote control

to the desired heat level.

If the desired ﬂue gas temperature of 350° C has not been achieved within 15 minutes, the remote control

will activate a re-stoking alarm even if there still might be wood and ﬂames in the combustion compart-

ment. The re-stoking alarm can seem misplaced, but it is activated because the temperature climbs too

slowly. Re-stoking with small pieces of kindling wood can often result in a faster increase in temperature.

HWAM Autopilot IHS

closes all three air dampers when the stove is in standby mode. This prevents

hot air from the room to enter the chimney (heat loss). This might on the other hand result in a very

cold chimney when the stove is lit. In certain cases it is necessary to assist the draught in the chimney

by burning a couple of newspaper pages on top of the wood ready to be lit. Read more on www.hwam.

com about the function of the chimney.

Important!

The ashpan must not be opened when lighting up. It must always be closed when the stove is in use.

Otherwise the stove’s intelligent control system does not function. The door should only be opened when

lighting up, when restoking, and when cleaning the stove.

The Thermostat Function

The HWAM Autopilot IHS

will in general have an environmentally friendly combustion and adapt to

the desired room temperature. The thermostat function is designed as a radiator valve. The user enters

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 2630 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 2630

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info