Bedienungsanleitung Hwam 3110 (Seite 10 von 20) (Englisch)

571926

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Page 10 of 20 pages

Model Weight Height Width Depth

HWAM 3110c/3110m 87 kg/84 kg 75,5 cm 47,9 cm 41,4 cm

HWAM 3110c/3110m on a pedestal 101 kg/98 kg 105,5 cm 47,8 cm 41,3 cm

HWAM 3120c/3120m 107 kg/104 kg 100,5 cm 47,9 cm 41,4 cm

HWAM 3130c/3130m 113 kg/110 kg 126,0 cm 47,9 cm 41,4 cm

Heat storage stones, HWAM 3130 32 kg

Floor plate

European, national and local regulations must be observed in terms of the size and thickness of a non-

combustible ﬂoor covering the ﬂoor in front of the combustion chamber opening. Ask your HWAM

retailer for assistance. The combustion chamber opening is 34.0 cm wide.

Distance to combustible materials

If HWAM 3110 is placed on a combustible ﬂoor, always mount it on a plinth whether or not the ﬂoor is

covered by a non-combustible material, such as a plate of glass or steel. The plinth is an accessory. Contact

your HWAM retailer for more information.

Min. distances - uninsulated ﬂue gas pipe (drawing A) HWAM 3110

HWAM 3120

HWAM 3130

1. Recommended for brick wall 10 cm

1. For combustible back wall 10 cm

2. For combustible side wall 20 cm

1.To combustible wall,corner installation, 45º 13 cm

3. Distance to furnishings in front 80 cm

For wall-mounting, HWAM 3110 must be placed at least 3 cm above any combustible ﬂooring. This also

applies to any ﬂoorboard placed on the ﬂoor.

Remember to pay attention to the applicable regulations concerning the required distance

between the wall and smoke pipe.

The distance to a brick wall is set to faciliate the servicing of the HWAM® Autopilot™. HWAM 3110

may be mounted with wall ﬁttings only on a brick wall. The stove must be taken down when the HWAM®

Autopilot™ is to be serviced.

Please be aware that not all glass parts are heat-resistant. For this reason, a glass wall should sometimes

be treated as a ﬂammable wall, in which case we ask you to contact your local chimney sweep or glass

producer to hear at what distance the stove should be kept from glass.

Requirements for chimney and smoke pipe

The height of the chimney must ensure sufﬁcient draught and prevent any smoke nuisance. As a general

rule, satisfactory draught conditions are achieved if the chimney is 4 m above the stove and at least 80

cm above the ridge. If the chimney is placed at side walls, the top of the chimney should always be higher

than the ridge or the tallest point of the roof. Always be aware of any national and/or local regulations

applying to thatched roofs and the location of the chimneys.

The woodburning stove requires a minimum draught of 12 Pa (measured at EN 13240 measurement

point). If measured just above the smoke ﬂue socket, the chimney draught must be 18-20 Pa.

The chimney must have a minimum clearing of Ø 150 mm. The chimney must be provided with an

easily accessible cleaning door. The chimney and ﬂue duct must be of ﬂue class T400 and be CE marked.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3110 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3110

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info