Bedienungsanleitung Hwam 3120 (Seite 15 von 20) (Englisch)

571927

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Page 15 of 20 pages

FIrIng In general

Rapid or ﬁerce heat

Rapid or ﬁerce heat is obtained by burning many small pieces of wood.

Maximum amounts of fuel:

The maximum allowed amount of fuel per hour is:

Wood: 2.0 kg

If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may

also become damaged due to excessive heat, the glass may turn white, for example.. The stove has been

approved for intermittent use.

Typical re-ﬁring interval

Typical re-ﬁring interval at nominal performance

Wood: 54 min. (1,3 kg)

Prolonged burning time

The longest burning time is achieved by turning the air control knob counter-clockwise (to the left) when

the ﬂames are about to die. This will ensure the longest period with embers. When adding new ﬁrewood,

always remember to check that the wood has caught ﬁre properly. If not, the air supply must be increased

by turning the air control knob to the right. When the air control knob is turned all the way to the left,

no primary air will enter the wood-burning stove through the bottom plate in the combustion chamber.

The stove cannot be lit after a new ﬁring without the air control knob being turned to the right, which

allows primary air to enter the unit.

If the air control knob is turned 45º from its minimum position (i.e. set at 25% capacity), the stove can

restart following a new ﬁring without further adjustment.

Insufﬁcient ﬁring

If the ﬁreproof materials in the combustion chamber are blackened after a ﬁre, then the stove is pollut-

ing, and the automatic air ﬂow regulation system is malfunctioning. Therefore, more air must be supplied

by turning the air control knob clockwise (to the right). It may also be necessary to burn more wood.

How to achieve the best combustion

• Use clean and dry wood.

Wet wood results in inefﬁcient combustion, plenty of smoke, and soot. Furthermore, the heat will dry

the wood, not heat up the room.

• The ﬁre should only be stoked with a little wood at a time.

You achieve the best combustion by starting up a ﬁre often and using only a little wood. If you use

too much ﬁrewood, it will take some time before the temperature reaches a level where you achieve

a good combustion.

• Make sure there is the right amount of air.

You should also make sure that there is plenty of air – especially in the beginning - so the temperature

in the wood burning stove climbs quickly. In this way the gasses and particles released during the

combustion will be consumed by the ﬁre. Otherwise they build up soot in the chimney (constituting

a chimney ﬁre risk) or will be released in a non-combusted state into the environment. The wrong

amount of air supply creates inefﬁcient combustion and a modest effect.

• Don’t savour the ﬁre during night time

We advise against adding ﬁre wood to your stove and reducing the air supply at night in an attempt to still

have some embers left in the morning. If you do so, large amounts of hazardous smoke will be emitted, and

your chimney will be exposed to unnecessarily large amounts of soot with the risk of a chimney ﬁre.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3120 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3120

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info