Bedienungsanleitung Hwam 3620 (Seite 15 von 60) (Englisch)

571936

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

The restoking alarm

When the combustion progresses to the ember phase, a restoking alarm will go off.

The alarm will light up three times with a ten second interval and it is supported

by sound.

Threedifferentamountsofwoodarerecommendedforrestoking:

A small amount of wood (700 - 1200 g)

A medium amount of wood (1000 - 2000 g)

A large amount of wood (1800 - 3000 g)

You must use at least two pieces of ﬁrewood at a time, even if you only want to use

a small amount of wood. The temperature causes the wood to gasify. Two pieces of

ﬁrewood heat up each other and increase their temperature faster.

A reminder of the restoking alarm

If a restoking alarm has gone off, and no restoking has been carried out, this symbol

will ﬂash on and off in the upper left corner.

If the symbol has been displayed for a long time, the temperature in the ﬂue gasses

can be so low that you have to light up again in order to give the stove more air

(this is done by pressing the remote control twice, causing the lighting up symbol

to appear in the display).

Always be aware that the status line changes from the burning out phase to the

combustion process phase when the stove is relit. Thereby you ensure that the

stove has registered that you have added new ﬁrewood which requires an adequate

amount of air. The oxygen level in the combustion compartment increases when

the door is opened. This sends a signal to the stove that new ﬁrewood has been

added to the ﬁre. Towards the end of the burning out phase, the oxygen level in the

combustion compartment can be so close to the oxygen level in the room that the

increase in the oxygen level in the combustion compartment due to the opening

of the door cannot be registered. If, shortly after relighting, the status line does not

alter from burning out phase to combustion process phase, you should press the

remote control twice until the lighting up symbol (the matchbox) appears.

Updating

When the Air box is updated with new software (by a service technician), this will

be displayed graphically.

Advanced menu

The remote control has a menu in which more advanced settings, etc. can be changed.

By pressing the button on the remote control for more than ﬁve seconds, you get

intotheadvancedmenu:

Thesearethemainmenus:

•Sound(turnthesoundonandoff)

•Self-test(initiatethe"Self-test",forinstancewhenaservicetechnicianvisits)

•Systeminfo(whichversionofthesoftwareisintheAirboxandintheremote

control respectively)

•Linktostove(shouldbeappliedwhenaremotecontrolismatchedwithanAir

box. This should be done at the factory)

Updating

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3620 Seite 15

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3620

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info