Bedienungsanleitung Hwam 3760 (Seite 17 von 20) (Englisch)

744527

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Page 17 of 20 pages

Cleaning the glass

We recommend wiping the glass after a ﬁre. This is best done using a paper towel.

Types of fuel

The stove may be damaged by very high temperatures and the glass may turn white, for example. This can

be avoided by never allowing the stove to burn with the ashpan open and taking great care with types of

fuel that develop excessive heat, such as briquettes.

We recommend using birch or beechwood, which has been split and stored for at least one year outdoors

under cover. Wood stored indoors tends to become too dry and burn too quickly.

Briquettes give off a lot of heat. Certain types expand considerably, thus causing an uncontrollable combustion.

The stove is EN 13240 approved for ﬁring wood only. No particle board, lacquered, painted

or treated wood, plastics, or rubber may be burned.

maIntEnancE

Cleaning

Any maintenance of the stove should only be carried out when it is cold. Daily maintenance is limited to

vacuum cleaning the stove externally, using the soft brush attachment. You can also dust the stove using a

dry, soft cloth or brush. But remember, only when the stove is cold. Do not use water, spirit or any other

kind of cleaner, as this will damage the lacquer.

Once a year, the stove should be thoroughly serviced. The combustion chamber should be cleared of ashes

and soot. The hinges and the closing hook must be greased with liquid copper fat spray (heat-resistant

up to 1100 °C), see drawing H. Lift the door approx. ½ cm and spray copper fat onto the hinge leaf.

Service inspection

Your stove should be given a thorough, preventive inspection once every two years. This includes:

• Thorough cleaning of the stove.

• Check the spring in the Autopilot unit and replace if necessary.

• Checking gaskets. Replace gaskets if they are not intact or have softened.

• Checking of heat insulating material and possibly replacement.

• Checking of the bottom/shaking grate.

• Use copper grease for hinges and locking hooks (see drawing H).

All service checks must be performed by an authorised ﬁtter. Use only original spare parts.

Inside cleaning

Before chimney sweeping can be performed, the regulator must be set to its minimum position to prevent

soot and ash from entering the Autopilot control.

The smoke shelf and bafﬂe plate is to be removed from the stove before cleaning (Drawing F).

• First lift the smoke shelf (1) out of the steel rail (2) at the back of the combustion chamber. Next, lower

it beneath the holders (3) and slide it out.

• Lift each half of the steel smoke plate (4) off the holder (5) behind the smoke pipe, and remove them

from the hook (6) beneath the top plate.

Ashes

The ash pan is best emptied by pulling a waste bag over the pan, tipping it and then carefully pulling it out

of the bag. Ashes are disposed of via the domestic waste collection.

Please note that there may be embers in the ashes for up to 24 hours after the ﬁre has

gone out!

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 3760 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 3760

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info