Page 15 of 20 pages
glass, keep the door ajar for a little while and close again. When the kindling is burning well, push the air
control lever (1) to middle position. If the fire goes out, this has been done too early. Push the air control
lever to the right again until the fire is burning properly. Allow the kindling to burn out until flames are
no longer visible. The stove can then be stoked again.
Booster
Pull out the shaking grate lever (2) completely to activate the booster if the wood does not burn easily
due to poor chimney draft. IMPORTANT: For safety reasons, it may only be used during the first 3 minutes.
As soon as the temperature in the combustion chamber is high enough and the draft in the chimney suf-
ficient, push the lever all the way back in again. This ensures safe and efficient combustion. It reactivates
the air wash system and avoids overheating of the stove. The booster is intended solely to assist in the
event of poor draft during the first 3 minutes of the lighting process. A chimney draft of 12 Pa does not
require the use of the booster.
Important! Only open the door when lighting the stove, refuelling it and cleaning it.
Stoking (drawing F)
When no more yellow flames are visible and a suitable layer of embers has built up, the stove can be
stoked again. There is a suitable layer of embers when the bottom of the stove is covered completely and
the embers are glowing in a circle around the shaking grate. Put at least 2 pieces of wood into the stove,
weighing up to 1 kg each. HWAM
®
Autopilot™manages the regulation of air supply. The temperature can,
however, be set up or down by pushing the air control lever either to the right or left, respectively. If the
air control lever is set farther to the left, combustion is reduced and the burning time is prolonged. By
pushing it to the right, combustion is increased and burning time is shortened. Do not add new firewood
to the fire until the layer of embers is sufficiently low.
During combustion, the outer surfaces of the stove will become hot, and due care must
therefore be shown.
When burning is complete
When the stove is not in use, push the air control lever all the way to the left.
Cleaning the glass
We recommend wiping the glass after a fire. This is best done using a paper towel.
Fuelling with coal or pet coke
The stove is not approved to use coal or pet coke as a fuel.
Remember that the regulator must then be turned to the left again.
