Bedienungsanleitung Hwam 4510 (Seite 17 von 20) (Englisch)

744536

Zoom out

Zoom in

Vorherige Seite

1/20

Nächste Seite

Types of fuel

The stove may be damaged by very high temperatures and the glass may turn white, for example. This

can be avoided by never allowing the stove to burn with the door open and taking great care with types

of fuel that develop excessive heat, such as briquettes.

We recommend using birch or beechwood, which has been split and stored for at least one year outdoors

under cover. Wood stored indoors tends to become too dry and burn too quickly.

Briquettes give off a lot of heat. Certain types expand considerably, thus causing an uncontrollable combustion.

The stove is EN 13240 approved for ring wood only. No particle board, lacquered, painted

or treated wood, plastics, or rubber may be burned.

mainTenanCe

Cleaning

Any maintenance of the stove should only be carried out when it is cold. Daily maintenance is limited to

vacuum cleaning the stove externally, using the soft brush attachment. You can also dust the stove using a

dry, soft cloth or brush. But remember, only when the stove is cold. Do not use water, spirit or any other

kind of cleaner, as this will damage the lacquer.

Once a year, the stove should be thoroughly serviced. The combustion chamber should be cleared of ashes

and soot. The hinges and the closing hook must be greased with liquid copper fat spray (heat-resistant up

to 1100°C), see drawing I. Lift the door approx. ½ cm and spray copper fat onto the hinge leaf.

Service inspection

Your stove should be given a thorough, preventive inspection once every two years. This includes:

• Thorough cleaning of the stove.

• Checking the spring in the Autopilot unit. Replace if necessary.

• Checking gaskets. Replace gaskets if they are not intact or are no longer soft.

• Checking and/or replacing insulation material.

• Checking the combustion chamber base.

• Use copper grease for hinges and locking hooks (see drawing I).

All service checks must be performed by an authorised tter. Use only original spare parts.

Inside cleaning

Before chimney sweeping can be performed, the regulator must be set to its minimum position to prevent

soot and ash from entering the Autopilot control.

Remove the top smoke shelf and the two-part steel smoke guide plate from the stove before cleaning.

(Drawing F)

• Lift the smoke shelf (1) out of the combustion chamber.

• Unhook each half of the smoke guide plate (2) from the hook (3) under the top plate.

Ashes

It is easiest to empty the ash pan by pulling a plastic bag over it, turning it upside down and then carefully

removing it from the bag. Ashes are disposed of via the domestic waste collection.

Please note that there may be embers in the ashes for up to 24 hours after the re has

gone out!

Insulation

The efcient, but porous insulation of the combustion chamber may, in time, become worn and damaged.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 4510 Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 4510

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info