Bedienungsanleitung Hwam 4640 (Seite 43 von 48) (Englisch, Dänisch, Schwedisch, Norwegisch)

613742

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

Stoking (drawing E)

When no more yellow ames are visible and a suitable layer of embers has built up, the stove can be

stoked again. A suitable ember layer is when the bottom of the combustion chamber is covered by embers

which are shining brightly. Put at least two pieces of wood into the stove, weighing up to 1.2 kg each. Do

not regulate the stove again as the Autopilot system will do this, but the temperature can be adjusted

with the regulator (1). Turning it to minimum (counter-clockwise) will reduce the rate of combustion and

make the stove burn slower. Turning to maximum (clockwise) will increase the rate of combustion and

make the stove burn faster. Wait until the layer of embers is suitably low before stoking again.

During combustion, the outer surfaces of the stove will become hot, and due care must

therefore be shown.

The stove is not approved to use coal or pet coke as a fuel. However, briquettes can be used to fuel the

re and should be placed on the embers produced by the burned wood. Turn the regulator to its full

clockwise position until the briquettes fully ignite.

Remember that the regulator must then be turned to the left again.

Be aware that using fuels other than wood, will cause soot to form on the glass pane.

Operating the heat compartment damper

There is a damper at the back of the stove between the top plate and the heat compartment that opens

and closes the ow of convection air in the heat compartment. The supply of convection air can be opened

by moving the damper to the left and closed by moving the damper to the right.

To store heat in the heat storage stones in the heat storage area as quickly as possible, it is recommended

that the convection vent be kept closed while the re is lit.

With the convection vent closed, the heat storage area retains the heat stored in the heat storage stones

for the longest possible duration. If the vent is opened, the heat stored in the stones in the heat storage

area will be released into the room as quickly as possible.

FIrIng In general

Rapid or erce heat

Rapid or erce heat is obtained by burning many small pieces of wood.

Maximum amounts of fuel:

The maximum allowed amount of fuel per hour is:

Wood: 3 kg

If these limits are exceeded, the stove will no longer be covered by the factory guarantee, and it may also

become damaged due to excessive heat. The stove has been approved for intermittent use.

Typical re-ring interval

Typical re-ring interval at nominal performance

Wood: 45 min (1.8 kg wood)

Long burning times

For the slowest possible combustion, turn the regulator counter-clockwise (to the left). By turning the regulator

all the way to the left, the stove receives no primary air (the air that comes through the grate). The stove cannot

be lit after a new ring without the regulator being turned to the right, which allows primary air to enter the unit.

After lighting, always check that persistent ames develop in the wood. If not, the air supply is too limited

and must be increased by turning the regulator to the right (clockwise).

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 4640 Seite 43

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 4640

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info