Bedienungsanleitung Hwam 7180 (Seite 10 von 52) (Englisch)

613747

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

• Thesmokeshelf(5).Tobeplacedontopofthesteelrailandontheholdersinthesides.

• Two-piecesmokedefectorplate(6).Eachhalfishungonthehookslocatedbeneaththetopplate.Thetwo

halves join in the holders behind the air pipe. Once the stove has been installed, twist the protection off

the two hooks by using pliers or a screwdriver.

• Removablerearplate(2).Thismustalwaysbemountedifthestoveisplacednexttoacombustiblewall.

• Looseheatshield(8)undertheashpan.Thiscanbeusedasalidwhentheashpanisremovedfor

emptying.

Connecting and preparing the HWAM Autopilot IHS

1. Connect the plug

a) to a normal 230V socket

b) to the Air box in the wood section underneath the combustion chamber (lead the plug through

the air slot at the bottom between the side and rear plates - on the left side of the wood-burning

stove when seen from the front. There is a mark on the Air box where the plug should be let in.

See the photo of the power supply on the Air box.

Air box without power supply. Air box with power supply.

2. Insert three AA batteries in the remote control. When the IHS logo disappears from the display, the

remote control is ready to use.

3. The remote control and the wood-burning stove must be connected (the factory will see to this).

If the status line at the bottom of the display is clear (empty) (

) and divided

into three sections, the wood-burning stove and the remote control are connected.

If the status line is dotted ( ), the remote control and the wood-burning stove

are not connected. Start with a display in which the light is off, and make the connection by pressing

and holding down the button, so the advanced menu is displayed. Then press the button repeatedly in

shortintervalsuntilthetext”Linktostove”ishighlightedandwaituntilitentersthismenu.Pressthe

button in short intervals until the text “Connect” is highlighted and wait again. When the text "Please

cycle stove power" appears on the display, disconnect the electricity from the Air box and then recon-

nect. Press the button once more. If the message "Connected to stove" shows up in the display, the

wood-burning stove and the remote control are connected. Press the button once to return to the

main menu. If you do not press the button again, the remote control automatically leaves the menu

and returns to the start display.

4. Go through the self-test of the HWAM Autopilot IHS

The self-test of the electronic control is carried out before lighting the ﬁrst ﬁre in the stove (the

factory will see to this). The self-test can only be done when the wood-burning stove is cold and in

standby mode (no signal in the status line

). Make sure that the display is

not active, i.e. there should be no light in the display (

). If there is light in the

display before you hold down the button for a while, you will instead prepare the wood-burning stove

for lighting (the matchbox will appear in the display) and no self-test can be carried out.

Press the remote control button for approx. 5 seconds in order to enter the menu. Press the button

until the cursor reaches “Self-test”. Wait a few seconds till the remote control enters the “Self-test”

menu. Press the button till the cursor reaches “Engage”. A few seconds later the self-test begins.

By going through a self-test you ensure that all basic operations function correctly.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam 7180 Seite 10

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Hwam 7180

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info