Bedienungsanleitung Hwam I45 (Seite 53 von 60) (Deutsch, Englisch, Dänisch, Schwedisch, Norwegisch)

571929

Zoom out

Zoom in

Vorherige Seite

1/60

Nächste Seite

Please note that it is important not to let go of the handle when opening and closing the door. The glass

could be damaged if the door is allowed to open or close on its own.

Regulating the insert (Drawing E)

The adjustment bar (1) is located behind the glass. The automatic control function is set to maximum when the

adjustment bar is set to the rightmost position, and minimum when the bar is set to the leftmost position.

Firing

Push the adjustment bar all the way to the right to set the automatic control to maximum effect. Put

split kindling, corresponding to two pieces of wood (about 2 kg), into the insert. Put two ﬁre lighters in

between the upper layer of kindling. Light them and allow the ﬂames to spread slowly. Keep the door

ajar until no more condensation forms on the glass (for a maximum of 5 min.). Close the door. When

the kindling is burning well, push the output regulating rod into middle position. If the ﬁre goes out, this

has been done too early. Push the regulating rod to the right again until the ﬁre is burning properly. Allow

the kindling to burn out until ﬂames are no longer visible.

Important! The door may only be opened when lighting the insert, adding fuel to the ﬁre or removing ash.

Burning

When there are no more visible yellow ﬂames, and a right ember is there, you can ﬁre again. The layer of

embers is suitable when the pieces of wood begin to disintegrate and the bottom of the insert is covered

by embers. Put two to three pieces of wood weighing up to 1 kg each into the insert. The automatic

control manages the regulation of air supply.

The temperature can, however, be set up or down by pushing the regulation bar either to the right or

left, respectively. If the adjustment bar is set farther to the left, combustion is reduced and the burning

time is prolonged. By pushing it to the right, combustion is increased and burning time is shortened. Do

not add new ﬁrewood to the ﬁre until the layer of embers is sufﬁciently low.

Burning coal, briquettes and coke

The HWAM I 30/45 is not designed for burning with coal or coke. However, briquettes can be used and

should be placed on the embers produced by the burned wood. Push the adjustment bar all the way to

the right until the briquettes are smouldering.

Remember that the adjustment bar should afterwards be pushed to the left again to reduce com-

bustion. Be aware that using fuels other than wood, will cause soot to form on the glass pane.

In general aBout FIrIng

Quick or strong heat

Quick or strong heat is obtained by burning many small pieces of wood.

Maximum amounts of fuel

The maximum allowed amount of fuel per hour is:

Wood: 2.3 kg Briquettes: 1.8 kg

Typical re-ﬁring interval at nominal performance

Wood: 65 min Briquettes: 65 min

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hwam I45 Seite 53

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info