Bedienungsanleitung Hyundai 57010 - HYM41P (Seite 27 von 36) (Englisch)

675901

Zoom out

Zoom in

Vorherige Seite

1/36

Nächste Seite

6.4.1. Cle

aning.

• DO NOT hose engine.

• Water can damage engine or contaminate the

fuel system.

6.4.1.1. Wipe deck with dry cloth.

6.4.1.2. You can hose under deck by tilting the

mower. Make sure you tilt the machine so that

the air filter is facing up.

6.4.1.3. Dry the machine completely to prevent

any rust forming. You can use a light oil or

silicone spray to prevent rust between.

6.4.2. Storage.

• When st

oring the machine make sure it has

been cleaned as in cleaning section 6.4.1.

• You can use a light oil or silicone spray to coat

the equipment.

6.4.2.1. The following steps should be taken to

prepare your lawnmower for storage.

6.4.2.2.1. After the final cut of the

season – you

must drain the fuel from the fuel tank. Then run

the machine until the engine comes to a stop

this allows the carburetor to be emptied of fuel.

6.4.2.2.2. Clean the mower completely and

make sure all moving parts are lubricated.

6.4.2.2.3. Check the blade to make sure that it is

ready for the following season – This will allow

you to get it sharpened correctly. Use a light oil

or silicone spray to help prevent the blade.

6.4.2.2.2.4. Once all work above is carried out

store the machine in a clean and dry place. DO

NOTE store a machine that has not been given

time to fully cool down.

7. TROUBLESHOOTING.

7.1. Engi

ne troubleshooting – where necessary

all corrective actions should be carried out by

suitably qualified persons.

7.2. If the starter rope becomes disconnected

from the rope guide on handle, disconnect the

spark plug cap. Depress the blade control

handle and pull the starter rope out from engine

slowly and re- engage in guide. Re connect spark

plug cap.

PROBLEM – ENGINE DOES NOT START.

Possible causes;

1. Throttle lever not in the correct position for

the prevailing conditions.

2. Fuel tank is empty.

3. Stale fuel

4. Air filter element is dirty.

5 .Spark plug is loose.

6. Spark plug cap loose or disconnected from

plug.

7. Spark plug gap is incorrect.

8. Carburetor is flooded with fuel.

9. Faulty ignition module.

10. Loose Operator Prescence Control cable.

Possible corrective actions;

1. Move throttle lever to correct position.

2. Fill tank with fuel.

3. Drain carburetor float bowl.

4. Clean air filter element.

5. Tighten spark plug to 25- 30Nm.

6. Make sure spark plug cap is correctly fitted

onto spark plug.

7. Set gap between electrodes at

0.7 to 0.8mm.

8. Remove air filter element and pull starter

rope continuously until carburetor clears.

9. Contact the service dealer.

10. Loose Operator Prescence Control cable.

ENGINE DIFFICULT TO START OR LOSES POWER.

Possible causes;

1. Dirt, water or stale fuel in tank.

2. Vent hole in fuel tank cap is plugged.

3. Air filter element is dirty.

Possible corrective actions;

1. Drain fuel and clean tank. Fill tank with clean,

fresh fuel.

2. Clean or replace fuel tank cap.

3. Clean air filter element.

Page 27

Revison 5 August 2016

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Hyundai 57010 - HYM41P Seite 27

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info