24
7.25 NEVER attempt to unclog either the feed hopper or discharge chute while the engine is
running.
Immediately shut off the engine, allow the cutting disk to come to a complete stop.
Remove the spark plug HT lead cap.
Remove the clogged material.
Inspect for damage and check for any loose parts for repair or replacement.
7.26 DO NOT tilt the machine while the engine is running.
7.27 ALWAYS stop the engine before moving the machine.
7.28 ALWAYS make sure that the engine is switched off and that the cutting disk and engine
are at a complete standstill and the spark plug HT lead cap has been removed, before
opening the cutting disk housing.
7.29 You MUST keep all combustible materials and substances away from the engine when
it is hot.
7.30 NEVER cover the machine while the exhaust is still hot.
7.31 Feed only clean materials into the machine. Foreign matter like soil, sand, grit, stones,
pieces of metal etc. will damage the sharp edge of the cutting knives.
Root balls and dead wood will also dull the blades quickly.
7.32 Avoid feeding any flax or roots into the machine, these stringy materials can wrap
themselves around the rotor shaft and work their way into the bearings.
7.33 DO NOT force branches into the machine.
Allow the machine to automatically feed through.
7.34 NEVER operate the machine on slopes.
7.35 DO NOT alter or adjust any part of the wood chipper or its engine that is sealed by the
manufacturer.
Only a qualified service technician may adjust parts that may increase or decrease
governed engine speed.
7.36 This wood chipper is for off-road use only.
NEVER attempt to tow the machine on public highways, roads or thoroughfares.
7.37 NEVER operate this machine without the feed hopper or discharge chute properly
attached to the machine.
7.38 Move the machine at least 3m away from the refuelling point before starting the engine.
7.39 ALWAYS check the oil level of the engine before use.
7.40 Inspect that all nuts and bolts are tight and well connected to ensure the safety and
reliability of this machine prior to any operation.
7.41 Inspect the air pressure in the tyres prior to use and pay attention to sharp objects when
moving the machine to prevent the tyres from being pierced.
