675917
13
Zoom out
Zoom in
Vorherige Seite
1/24
Nächste Seite
Rev 6 - 10/11/2015
4.6. Installing the discharged hose not supplied.
4.6.1. Connect the discharge hose(3) to the to the hose
connector (1) and hose clamp (2) provided with the pump
to install the discharge hose, then tighten the clamp.
Tighten the hose clamp ring screw in a clockwise direction
until hose is firmly secured to prevent hose becoming
detached.
4.6.2. For best results use a short, large-diameter hose as it
will reduce fluid friction and improve the pump output.
4.7. Priming the Pump.
Operating the pump is a dry unprimed condition will damage the pump seal.
If the pump has been accidently operated in a dry state, stop the engine immediately and
allow it to cool before priming.
4.7.1. Before starting the engine, place the water pump
on a flat level surface and fill the pump with water.
4.7.2. Unscrew the priming plug (1) and fill the pump
full with clean water.
4.7.3. After priming, reinstall the priming plug and
tighten.
4.7.4. DO NOT unscrew the priming plug during
operation of the water pump.
4.8. Using at high altitudes.
4.8.1. At high altitude, the standard carburetor air-fuel mixture will be excessively rich.
4.8.2. As a result output power will decrease, and fuel consumption will increase. The Air-fuel
mixture will be very likely to make the spark plug dirty and make starting difficult.
4.8.3. The engine performance can be improved by installing a main fuel jet of a smaller diameter
in the carburetor and readjusting the pilot screw. If you intend to regularly use the water
pump at altitudes greater than 1000m above sea level, contact us regarding a carburetor
modification.
4.8.4. Even with a suitable carburetor, the engine horsepower will decrease by around 3.5% for
each 300 meter increase in altitude. The effect of altitude on horsepower will be greater than
this if a carburetor modification is not made.
If a carburetor suitable to high altitude is equipped with an engine suitable to a lower altitude,
the lean air fuel mixture will lead to lower engine output power, over-heating and serious
damage.
13

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Hyundai 57604 - HYT80 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info