Bedienungsanleitung I-onik WS-210TX (Seite 8 von 8) (Deutsch, Englisch)

521904

Zoom out

Zoom in

Vorherige Seite

1/8

Nächste Seite

14 15

3. Maintenance

The product may be cleaned with a soft damp cloth and then wiped dry. Do not use

abrasive, solvent based or aerosol cleaners as this may damage and/or discolour the

product. Do not allow water to enter or attempt to clean inside the unit.

4. Batteries

Do not allow the batteries to corrode or leak as this may cause permanent damage to the

product. Take care to insert the batteries with the correct polarity as shown inside the

battery compartments. Do not mix new and old batteries or different types of batteries.

Do not use rechargeable batteries.

At the end of their useful life the batteries should be disposed of via a suitable recycling



5. Alarm System Limitations

Even the most advanced alarm systems cannot guarantee 100 % protection against

burglary or environmental problems.

All alarm systems are subject to possible compromise or failure-to-warn for a variety of

reasons.

Please note that you may encounter problems with your system if:



of the premises.





located).



of the system.





close to a heat source.

Note:

Inadequate maintenance is the most common cause of alarm failure; therefore,

test your system at least once per week to be sure the sensors and sirens are

working properly.

Although having an alarm system may make you eligible for reduced insurance

premiums, the system is no substitute for insurance.

Press then

to go into Remote

 mode,

and then press any

key on the remote to

check its ID.

- After entering into Remote

 mode, the LCD



number of remote controls

currently enrolled to the

system (e.g. if 3 remotes are

enrolled the LCD display will



- The ID no. of the remote

can then be checked by

pressing any key on the re-

mote (e.g, if the LCD display



ID of the remote).

Press

to complete

the query.

Complete the query and

return the Smart Panel to

STANDBY by pressing

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

I-onik WS-210TX Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info