48
12 POCKET BEEP AND TONE SQUELCH
■ Tone scan
By monitoring a signal that is being transmitted on a repeater
input frequency, you can determine the tone frequency nec-
essary to open a repeater.
➀ Set the frequency to be checked for a tone frequency e.g.
a repeater input frequency.
➁ Push [(TONE)T-SCAN] for 1 sec. to start the tone scan.
• To change the scanning direction, rotate the tuning dial.
➂ When the tone frequency is matched, the squelch opens
and the tone frequency is temporarily programmed into the
selected mode such as VFO, memory/call channel or
scratch pad memory.
• The tone scan pauses when a tone frequency is detected.
• The decoded tone frequency is used for the tone encoder or tone
encoder/decoder depending on the tone squelch ON/OFF set-
ting.
➃ Push [V/MHz] to stop the scan.
Ä Set the frequency to be checked for a tone fre-
quency e.g. repeater input frequency.
Å Push [F-2] for 1 sec. to start the tone scan.
Ç When the tone frequency is matched, the
squelch opens and the tone frequency is pro-
grammed into the selected mode such as VFO,
memory/call channel or scratch pad memory.
É Push [ECLR] to stop the scan.
☞ NOTE: The decoded tone frequency is programmed tem-
porarily when a memory or call channel is selected. How-
ever, this will be cleared when overwriting the memory/call
channel.
