53
11
PAGER/CODE SQUELCH
DD
Code programming
An ID code MUST be programmed into code channel C0. Up
to 6 transmit codes are programmable into code channels, C1
to C6, if required.
q Push [BANK ] for 1 sec. then rotate [DIAL] to turn
Pager mode ON.
• “PG” appears.
w Push [SET] or [MONI].
• One of either “CP” or “C0” to “C6” flashes.
• “C0” is the ID code and “C1” to “C6” are transmit codes.
e Rotate [DIAL] to select code channel C0.
•Adifferent ID code must be programmed into each transceiver.
r Push [MONI] (or [SET]) to set into code programming condi-
tion.
• The 1st digit blinks and “C0” indication stops blinking.
t Rotate [DIAL] to set the desired code.
y Push [MONI] (or [SET]) to select 2nd digit, then rotate
[DIAL] to set the desired code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for 3rd digit programming.
u Push [MONI] (or [SET]) to program the ID code.
• Long beep sounds and the “C0” indication blinks.
i Rotate [DIAL] to select a transmit code channel from “C1”
to “C6.”
o Repeat steps r to u to set transmit code channel.
!0 Push [S.MW ] to set the channel for “receive inhibit”
or “receive accept.”
• When “receive inhibit” is set, “SKIP” appears as follows.
• Code channel C0 cannot be set as “receive inhibit.”
• See p. 54 for “receive accept” and “receive inhibit” details.
!1
Push any key other than indicated function keys to exit code
set mode.
