12-14
12
SET MODE
■ Miscellaneous (Others) set mode
This item is used for a simple frequency check of the
transceiver. (default: OFF)
See p. 13-5 for calibration procedure.
NOTE: Turn the calibration marker OFF after
checking the frequency of the transceiver.
A beep sounds each time a switch is pushed to con-
firm it. This function can be turned OFF for silent op-
eration. (default: ON)
The beep output level can be set in level set mode.
(p. 12-5)
A beep sounds when an operating frequency enters
or exits an amateur band. This functions independent
of the confirmation beep setting (above). (default: ON)
The beep output level can be set in level set mode.
(p. 12-5)
Sets the desired key-touch beep sound frequency
during main readout operation within 500 to 2000 Hz
in 10 Hz steps. (default: 1000 Hz)
Set the different frequency from “Beep Sound (SUB)”
as below to distinguish between main and sub.
Sets the desired key-touch beep sound frequency
during sub readout operation within 500 to 2000 Hz in
10 Hz steps. (default: 1000 Hz)
Set the different frequency from “Beep Sound (MAIN)”
as above to distinguish between main and sub.
When this item is set to ON, pushing [DUALWATCH]
for 1 sec. sets the sub readout frequency to the main
readout frequency and activates dualwatch operation.
(default: ON)
See p. 5-16 for details.
