29
9
TROUBLESHOOTING
If your transceiver seems to be malfunctioning, please check
the following points before sending it to a service center.
PROBLEM POSSIBLE CAUSE SOLUTION REF.
No power comes on. • The battery is exhausted. • Recharge the battery pack. pgs. 7,
• Bad connection for the battery pack. • Check the connection to the transceiver. 25–27
No sound comes from • Squelch level is too deep. • Set squelch to the threshold point. pgs. 8, 9
the speaker. • Volume level is too low. • Set [VOL] to a suitable level.
Transmitting impossible. • Some channels are receive only. • Change channels. p. 8
• The battery is exhausted. • Recharge the battery pack. p. 25–27
The display channel • Lock function is activated. • Push , then push [7• ]. p. 11
can not be selected.
Scan does not start. • All memory channels are not programmed • Set the “TAG” settings of desired p. 17
programmed as “TAG” channels. channels.
No beep sounds. • Beep tones turned OFF. • Push , then push [8•
BEEP] to adjust p. 11
the beep tone level
