VII
QUICK REFERENCE GUIDE
■ Programmed scan operation
50 channels of memories in 25 pairs are used to specify
scanning ranges for programmed scan operation. The pro-
grammed scan scans between “xxA” and “xxb” (xx=00 to 24)
channels. Therefore, before operating the programmed scan,
different frequencies must be programmed into the “A” and
“b” channels.
DD
Programming scan edges
A start and stop frequency must be programmed into a pair
of "xxA" or "xxb" channels.
1. Setting frequency
In VFO mode, set the desired operating frequency and mode.
• When “ ” indicator is displayed, push [V/M] (
SKIP
•
S
.
MW
) to select
the VFO mode.
2. Selecting a scan edge channel “A”
Push and hold [V/M] (
SKIP
•
S
.
MW
) for 1
sec. to enter select memory write
mode (
1 short and 1 long beep
sound)
,
then rotate [DIAL] to select
the desired scan edge channel “A.”
•“ ” indicator and scan edge channel
number blink.
3. Writing a memory channel
Push and hold [V/M] (
SKIP
•
S
.
MW
) for 1 sec. until 3 beeps
sound.
• Scan edge channel “b” is automatically selected when continuing to
push [V/M] (
SKIP
•
S
.
MW
) after programming.
• After programming is completed, the display returns to VFO indica-
tion.
4. Selecting a scan edge channel “b”
Push and hold [V/M] (
SKIP
•
S
.
MW
) for 1
sec.,
then rotate [DIAL] to select the
desired scan edge channel “b.”
•“ ” indicator and scan edge channel
number blink.
• When the scan edge channel “b” is already selected at step 3, con-
tinuing to push [V/M] (
SKIP
•
S
.
MW
) after programming, skip this step.
5. Writing a memory channel
Push and hold [V/M] (
SKIP
•
S
.
MW
) for 1 sec. until 3 beeps
sound.
• The next scan edge channel “A” is automatically selected when con-
tinuing to push [V/M] (
SKIP
•
S
.
MW
) after programming.
• After programming is completed, the display returns to VFO indica-
tion.
