Bedienungsanleitung Icom IC-F33GT GS F43GT GS (MDC BIIS) (Seite 52 von 56) (Englisch)

12494

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromagnetic

energy during transmit mode. This radio is

designed for and classiﬁed as “Occupational Use

Only”, meaning it must be used only during the

course of employment by individuals aware of the

hazards, and the ways to minimize such hazards.

This radio is NOT intended for use by the “General Population” in

an uncontrolled environment.

This radio has been tested and complies with the FCC RF expo-

sure limits for “Occupational Use Only”. In addition, your Icom

radio complies with the following Standards and Guidelines with

regard to RF energy and electromagnetic energy levels and eval-

uation of such levels for exposure to humans:

• FCC OET Bulletin 65 Edition 97-01 Supplement C,

Evaluating Compliance with FCC Guidelines for Human

Exposure to Radio Frequency Electromagnetic Fields.

• American National Standards Institute (C95.1-1992), IEEE

Standard for Safety Levels with Respect to Human Exposure

to Radio Frequency Electromagnetic Fields, 3 kHz to 300

GHz.

• American National Standards Institute (C95.3-1992), IEEE

Recommended Practice for the Measurement of Potentially

Hazardous Electromagnetic Fields– RF and Microwave.

• The following accessories are authorized for use with this

product. Use of accessories other than those speciﬁed may

result in RF exposure levels exceeding the FCC require-

ments for wireless RF exposure.; Belt Clip (MB-94),

Rechargeable Li-Ion Battery Pack (BP-231) and Speaker-

microphone (HM-131L).

To ensure that your expose to RF electromag-

netic energy is within the FCC allowable limits

for occupational use, always adhere to the fol-

lowing guidelines:

• DO NOT operate the radio without a proper antenna

attached, as this may damaged the radio and may also

cause you to exceed FCC RF exposure limits. A proper

antenna is the antenna supplied with this radio by the manu-

facturer or antenna speciﬁcally authorized by the manufac-

turer for use with this radio.

• DO NOT transmit for more than 50% of total radio use time

(“50% duty cycle”). Transmitting more than 50% of the time

can cause FCC RF exposure compliance requirements to be

exceeded. The radio is transmitting when the “ ” (TX indi-

cator) lights. You can cause the radio to transmit by pressing

the “PTT” switch.

• ALWAYS keep the antenna at least 2.5 cm (1 inch) away

from the body when transmitting and only use the Icom belt-

clips listed on page 46 when attaching the radio to your belt,

etc., to ensure FCC RF exposure compliance requirements

are not exceeded. To provide the recipients of your transmis-

sion the best sound quality, hold the antenna at least 5 cm

(2 inches) from your mouth, and slightly off to one side.

The information listed above provides the user with the informa-

tion needed to make him or her aware of RF exposure, and what

to do to assure that this radio operates with the FCC RF expo-

sure limits of this radio.

CAUTION

WARNING

IC-F33_43GT_GS_MDC.qxd 06.7.19 2:09 PM Page 48 (1,1)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Icom IC-F33GT GS F43GT GS (MDC BIIS) Seite 52

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info