Bedienungsanleitung Icom IC-F80DT (Seite 44 von 48) (Englisch)

670362

Zoom out

Zoom in

Vorherige Seite

1/48

Nächste Seite

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromagnetic

energy during transmit mode. This radio is

designed for and classified as “Occupational

Use Only”, meaning it must be used only during

the course of employment by individuals aware

of the hazards, and the ways to minimize such

hazards. This radio is NOT intended for use by the “General

Population” in an uncontrolled environment.

This radio has been tested and complies with the FCC RF

exposure limits for “Occupational Use Only”. In addition, your

Icom radio complies with the following Standards and

Guidelines with regard to RF energy and electromagnetic

energy levels and evaluation of such levels for exposure to

humans:

• FCC OET Bulletin 65 Edition 97-01 Supplement C,

Evaluating Compliance with FCC Guidelines for Human

Exposure to Radio Frequency Electromagnetic Fields.

• American National Standards Institute (C95.1-1992),

IEEE Standard for Safety Levels with Respect to Human

Exposure to Radio Frequency Electromagnetic Fields, 3

kHz to 300 GHz.

• American National Standards Institute (C95.3-1992),

IEEE Recommended Practice for the Measurement of

Potentially Hazardous Electromagnetic Fields– RF and

Microwave.

• The accessories (antennas, batteries, belt clips, speaker-

microphone, etc. that is listed on Pages 37–38) are

authorized for use with this product. Use of accessories

other than those speciﬁed may result in RF exposure lev-

els exceeding the FCC requirements for wireless RF

exposure.

To ensure that your expose to RF electro-

magnetic energy is within the FCC allow-

able limits for occupational use, always

adhere to the following guidelines:

• DO NOT operate the radio without a proper antenna

attached, as this may damaged the radio and may also

cause you to exceed FCC RF exposure limits. A proper

antenna is the antenna supplied with this radio by the

manufacturer or antenna specifically authorized by the

manufacturer for use with this radio.

• DO NOT transmit for more than 50% of total radio use

time (“50% duty cycle”). Transmitting more than 50% of

the time can cause FCC RF exposure compliance

requirements to be exceeded. The radio is transmitting

when the TX indicator lights red. You can cause the radio

to transmit by pressing the “PTT” switch or VOX function.

• ALWAYS keep the antenna at least 2.5 cm (1 inch) away

from the body when transmitting and only use the Icom

belt-clips listed on page 37 when attaching the radio to

your belt, etc., to ensure FCC RF exposure compliance

requirements are not exceeded. To provide the recipients

of your transmission the best sound quality, hold the

antenna at least 5 cm (2 inches) from your mouth, and

slightly off to one side.

The information listed above provides the user with the infor-

mation needed to make him or her aware of RF exposure,

and what to do to assure that this radio operates with the

FCC RF exposure limits of this radio.

CAUTION

WARNING

IC-F70_F80-1.qxd 05.1.18 4:26 PM Page 40 (1,1)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Icom IC-F80DT Seite 44

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info