Bedienungsanleitung Icom IC-M88 (Seite 2 von 40) (Englisch)

12686

Zoom out

Zoom in

Vorherige Seite

1/40

Nächste Seite

SAFETY TRAINING INFORMATION

Your Icom radio generates RF electromagnetic energy during

transmit mode. This radio is designed for and classified as

“Occupational Use Only”, meaning it must be used only during

the course of employment by individuals aware of the haz-

ards, and the ways to minimize such hazards. This radio is

NOT intended for use by the “General Population” in an un-

controlled environment.

This radio has been tested and complies with the FCC RF exposure limits for

“Occupational Use Only”. In addition, your Icom radio complies with the follow-

ing Standards and Guidelines with regard to RF energy and electromagnetic

energy levels and evaluation of such levels for exposure to humans:

• FCC OET Bulletin 65 Edition 97-01 Supplement C, Evaluating Compliance

with FCC Guidelines for Human Exposure to Radio Frequency Electro-

magnetic Fields.

• American National Standards Institute (C95.1-1992), IEEE Standard for

Safety Levels with Respect to Human Exposure to Radio Frequency Elec-

tromagnetic Fields, 3 kHz to 300 GHz.

• American National Standards Institute (C95.3-1992), IEEE Recommended

Practice for the Measurement of Potentially Hazardous Electromagnetic

Fields– RF and Microwave.

To ensure that your expose to RF electromagnetic en-

ergy is within the FCC allowable limits for occupational

use, always adhere to the following guidelines:

• DO NOT operate the radio without a proper antenna at-

tached, as this may damaged the radio and may also cause

you to exceed FCC RF exposure limits. A proper antenna is the antenna sup-

plied with this radio by the manufacturer or antenna speciﬁcally authorized by

the manufacturer for use with this radio.

CAUTION

WARNING

• DO NOT transmit for more than 50% of total radio use time (“50% duty

cycle”). Transmitting more than 50% of the time can cause FCC RF expo-

sure compliance requirements to be exceeded. The radio is transmitting

when the “TX indicator” lights red. You can cause the radio to transmit by

pressing the “PTT” switch.

• ALWAYS use Icom authorized accessories (antennas, batteries, belt clips,

etc.). Use of unauthorized accessories can cause the FCC RF exposure

compliance requirements to be exceeded.

• ALWAYS keep the antenna at least 2.5 cm (1 inch) away from the body

when transmitting and only use the Icom belt-clips which are listed on

page 31 when attaching the radio to your belt, etc., to ensure FCC RF ex-

posure compliance requirements are not exceeded. To provide the recipi-

ents of your transmission the best sound quality, hold the antenna at least

5 cm (2 inches) from your mouth, and slightly off to one side.

The information listed above provides the user with the information needed to

make him or her aware of RF exposure, and what to do to assure that this radio

operates with the FCC RF exposure limits of this radio.

Electromagnetic Interference/Compatibility

During transmissions, your Icom radio generates RF energy that can possibly

cause interference with other devices or systems. To avoid such interference,

turn off the radio in areas where signs are posted to do so. DO NOT operate

the transmitter in areas that are sensitive to electromagnetic radiation such as

hospitals, aircraft, and blasting sites.

IC-M88-2.qxd 02.11.22 3:24 PM Page ii (1,1)

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Icom IC-M88 Seite 2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info