30
5
MEMORY OPERATION
5
■ Programming channel names
Each memory channel and the call channel can be pro-
grammed with an alphanumeric channel name for easy
recognition and can be indicated independently by channel.
Names can be a maximum of 6 characters— see the table
below for available characters.
q Push [M/CALL(PRIO)] to select memory mode.
w
Rotate the tuning dial to select the desired memory channel.
e Push [MONI(ANM)] for 1 sec. to select channel name in-
dication mode.
• 1 short and 1 long beep sound.
r Push [SET(LOCK)] to select the channel name program-
ming condition.
• Frequency readouts disappear.
t Rotate the tuning dial to select the desired character.
• The selected character blinks.
y Push [SET(LOCK)] or [MW(S.MW)] to move the cursor to
left or right, respectively.
u Repeat steps t and y until the desired channel names
are displayed.
i Push [V/MHz(SCAN)] to program the name and exit the
channel name programming condition.
o Push [MONI(ANM)] for 1 sec. to return to frequency indi-
cation if desired.
IMPORTANT!: Once channel name indication mode is
selected, always access the channel name programming
condition when [SET(LOCK)] is pushed.
When set mode accessing is necessary, cancel the chan-
nel name indication by pushing [MONI(ANM)] for 1 sec.,
then access to set mode.
