38
7
SCAN OPERATION
7
■ Scan start/stop
D Preparation
Scan resume condition (p. 42); program the scan edges
(pgs. 39, 40); program 2 or more memory channels (pgs. 25,
26); set skip settings, if desired (p. 41).
D Operation
q Select VFO mode for full/programmed scan with
[V/MHz(SCAN)]; or memory mode for memory scan with
[M/CALL(PRIO)].
• Select the desired bank with [BANK(OPT)] for bank scan.
w Set the squelch to the point where noise is just muted.
e Push [V/MHz(SCAN)] for 1 sec. to start the scan.
• To change the scanning direction, rotate the tuning dial.
• The memory channel readout blinks the scan type as follows:
r Push [SET(LOCK)] to switch full and programmed scan
(P1, P2 and P3).
t To stop the scan, push [V/MHz(SCAN)].
z Push [VFO/LOCK] to select VFO mode for
full/programmed scan; push [MR/CALL] to select
memory mode for memory scan.
• Push [BANK/OPTION] to select a bank for bank
scan.
x Set the squelch to the point where noise is just
muted.
c Push [
SCAN
2(T-SCAN)] to start the scan.
• Push [Y] or [Z] for 1 sec. also starts the scan.
v Push [
SET
B(D-OFF)] to switch full and pro-
grammed scan (P1, P2 and P3).
b To stop the scan push [
SCAN
2(T-SCAN)] or
[
CLR
A(MW)].
• During full scan • During programmed scan • During memory scan
Indicates scan edge channels.
• P1 stands for 1A/1b
• P1 to P3 are available when they
are programmed, and switches
with [SET(LOCK)].
Push [SET(LOCK)] to select full or
programmed scan (P1, P2 and
P3) in sequence.
