8
SCAN OPERATION
31
■ Frequency skip function
D Programming a skip frequency
Unwanted frequencies can be skipped and programmed as
skip channels when full or programmed scan is pausing.
q Turn ON the frequency skip function as described at right.
w Start full scan or programmed scan. (p. 29)
e While receiving an unwanted signal and scan pauses,
push [
(S.MW)MW] for 2 sec. to program the received fre-
quency as a skip frequency.
•Do not release [(S.MW)MW] before 2 sec., otherwise, scan stops
and select memory mode is selected.
•The transceiver emits 3 beeps and the scan resumes.
•Non-programmed memory channels are used for skip frequency
programming from channel 99 to 10 in reverse sequence.
•To scan the skip frequency after programming, cancel the skip
information or clear the memory channel. (pgs. 25, 30)
NOTE: When the frequency skip function is turned OFF,
the paused frequency is overwritten on the preselected
memory channel.
D Frequency skip function ON/OFF
The frequency skip function can be turned OFF in set mode.
In this case, the frequencies will not be skipped even if skip
information is programmed and “” will not blink during full
scan or programmed scan.
SETTING THE FREQUENCY SKIP FUNCTION ON/OFF
q Turn power ON while pushing [(MAIN)SCAN] to enter
scan set mode.
w Push [
(H/L)J] or [(TONE)K] several times until “SKIP SC”
appears as shown above.
e Rotate [DIAL] to turn the frequency skip function ON or
OFF.
r Turn power OFF to exit scan set mode.
USING
Scan set mode
