Bedienungsanleitung Icom ID-51A (Seite 17 von 56) (Englisch)

689583

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

New2001

D When using the GPS receiver

•GPSsignalscannotpassthroughmetalobjects.Whenus-

ing the ID-51A or ID-51E inside a vehicle, you may not re-

ceive GPS signals. We recommend you use it near a win-

dow. Please avoid the areas shown in the following:

 1.DONOTusewhereitwillblockthedriver’sview.

2. DO NOT use where the air bags could deploy.

3. DO NOT use where it becomes a driving obstacle.

•TheGlobalPositioningSystem(GPS)isbuiltandoperated

by the U.S. Department of Defence. The Department is re-

sponsible for accuracy and maintenance of the system. Any

changes by the Department may affect the accuracy and

function of the GPS system.

•When the GPS receiver is activated,please do not cover

theID-51AorID-51Ewithanythingthatwillblockthesatel-

lite signals.

•TheGPSreceivermaynotworkifusedinthefollowingloca-

tions:

1. Tunnels or high-rise buildings

 2.Undergroundparkinglots

3. Under a bridge or viaduct

4. In remote forested areas

5. Under bad weather conditions (rainy or cloudy day)

•TheGPSreceivermaynotworkifthetransceiveroperates

near the 440.205 MHz. This is due to signals made in the

internal circuit and does not indicate a transceiver malfunc-

tion.

D Spurious signals

Depending on the combination of the operating band and

mode, the Dualwatch or Triple-watch operation may generate

certain spurious signals, or noise may be heard. These do not

indicate a transceiver malfunction.

About charging at power ON

ID-51A/E’schargingcircuitchargesthesuppliedbatterypack

in approximately 3 hours. But with this rapid circuit, the bat-

terypackcannotbechargedatpowerON,bydefault.So,be

sure to turn OFF the power before charging.

When “Charging (Power ON)”* is set to ON in the MENU screen,

thebatterypackcanbechargedevenifthepowerisON.(Only

whenthebattery packisattached,andtheoptional CP-12L,

CP-19RorOPC-254LexternalDCpowercableisconnected

to [DC IN].) But this operation may generate certain spurious

signals; the S-meter appears, or noise may be heard.

*MENU > Function > Charging (Power ON) (Default: OFF)

•Charging time period at powerON may differ, depending on the

operating condition.

•TheexternalDCpowersupplyvoltagemustbebetween10–16V,

and the current capacity must be more than 2.5 A to charge the

batterypackwhenoperating.

•Whenyouoperatethetransceiverwhilecharging,andifyoucannot

receive signals correctly, set “Charging (Power ON)”* to OFF, and

disconnect the external DC power cable from [DC IN].

IMPORTANT NOTES

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Icom ID-51A Seite 17

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Icom ID-51A

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info