689584
397
Zoom out
Zoom in
Vorherige Seite
1/413
Nächste Seite
TROUBLESHOOTING
20-3
DOthers
PROBLEM POSSIBLE CAUSE SOLUTION REF.
Transceiver does not turn
ON.
The battery is exhausted.
The battery polarity is reversed.
Loose connection of a battery pack
(case).
Charge the battery pack, or replace the
batteries.
• Check the battery polarity in the case.
• Clean the battery terminals.
pp. 4-3, 4-4
p. 4-4
pp. 4-3, 4-4
No sound comes from the
speaker.
Volume level is too low.
An external speaker or a cloning cable
is connected to the [SP] jack.
Rotate [VOL] to adjust to a desired
level.
Check the external speaker connection
or remove the cloning cable.
p. 5-2
Sensitivity is too low, and
only strong signals are au-
dible.
The coaxial cable is not connected, or
shorted. (External antenna is used)
Check the coaxial cable connection or
replace with the new.
Transmitting is impossible. The transmit power level is set to S-
LOW, LOW1 or LOW2
The battery is exhausted.
The battery case is attached.
The PTT Lock function is activated.
The Busy Lockout function is activated.
Set the transmit power level to HIGH.
Charge the battery pack, or replace the
batteries.
Use the battery pack or external DC
power, and set the transmit power level
to HIGH.
Set the PTT Lock function to OFF in
the Function Menu.
Set the Busy Lockout function to OFF
in the Function Menu.
p. 5-11
pp. 4-3, 4-4
pp. 4-6, 5-10
p. 16-75
p. 16-75
No reply is received after a
call.
The duplex is set, and the receive and
transmit frequencies are different.
No station is in range or on the same
frequency.
Set the simplex operation.
Wait for a while, and try again.
p. 15-5
Transmitting using the VOX
function is impossible.
The VOX Level is set to OFF or too low.
The MIC Gain is too low.
Set the VOX Level to a suitable level.
Set the MIC Gain to a suitable level.
p. 16-77
p. 16-76
Contacting another station is
impossible.
A different tone or code is used for the
tone/DTCS squelch.
Check the tone/DTCS by performing a
tone scan.
p. 13-2
Frequency cannot be set. The Key Lock function is activated.
The memory mode, Call channel mode,
Weather channel mode* or DR function
is selected.
*USA version transceiver only
Hold down [LOCK] for 1 second to
cancel the Key Lock function.
Push [V/MHz] to select the VFO
mode.
p. 5-12
p. 5-10
A Program Scan does not
start.
The memory mode, Call channel mode,
Weather channel mode* or DR function
is selected.
*USA version transceiver only
The same frequency has been pro-
grammed in the scan edge channels,
A” and “B.”
Only one scan edge channel has been
programmed.
Push [V/MHz] to select the VFO
mode.
Program different frequencies in the
scan edge channels.
Program one or more pair of the scan
edge channels.
p. 5-10
p. 12-4
p. 12-4
A Memory Scan does not
start.
The Memory mode is not selected.
Only one or no memory channel has
been programmed.
Push [M/CALL] to select the Mem-
ory mode.
Program two or more memory chan-
nels.
p. 5-10
p. 12-4
The displayed frequency is
erroneous.
The CPU has malfunctioned.
• External factors have caused a fault.
• Reset the transceiver.
Remove and reattach the battery pack/
case.
p. 16-99
p. 1-2
Previous view
397

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Icom ID-51E wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Icom ID-51E

Icom ID-51E Kurzanleitung - Englisch - 56 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info