311701
2
Zoom out
Zoom in
Vorherige Seite
1/2
Nächste Seite
5019 100 01018
Programmes with prewash last about 15 minutes more than programmes without prewash. Water and energy
consumption values were measured in standard conditions in compliance with the Standard IEC 60 456. Individual
consumption may vary in comparison with the values specified in the table, because of differences in supply water
pressure and temperature, the load and the type of wash.
ADDING DETERGENT AND ADDITIVES
Pour the detergent and additives into the respective
compartments as follows:
Programme with pre and main wash
Main wash programme without prewash
Fabric softeners and starch
Stain removers
Anti-scale agents (water hardness 4)
Important Note:
Do not fill beyond the
MAX
level mark.
For programme with prewash: do not use liquid
detergent.
For programmes without prewash from cold to 40° C, it is recommended to use a liquid
detergent to avoid whitish residues on the coloured laundry.
CLOSE THE DOOR AND SELECT THE PROGRAMME
Turn the
programme selector knob
clockwise to the desired programme.
PRESS ANY DESIRED OPTION BUTTON(S)
Half Load button
Reduces the water consumption in the Cotton and Synthetics programmes
especially during the rinse.
Especially suitable for lightly soiled or small loads (reduces the quantity of detergent).
Not suitable for high temperature programmes.
PROGRAMME START
Open the water inlet tap and press the On/Off button. The pilot lamp lights up.
DOOR LOCK
During the running programme, the door cannot be opened.
The door locks automatically in all programmes.
If the programme is stopped or if an electrical power failure occurs, the door unlocks
automatically after about 1 minute.
PROGRAMME END
The programme selector knob is at STOP.
1. Press the On/Off button. The pilot light goes out.
2. Cancel the option by pressing the appropriate button.
3. Turn the water supply tap off.
4. Wait for the door to unlock (about 1 minute).
5. Open the door and the drum flaps and unload the machine.
SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER
PROGRAMME START
1. Press the On/Off button to switch off the appliance.
The pilot light goes out.
2. Select the new programme and option.
3. Press the On/Off button to switch on the appliance.
The pilot light lights.
TO STOP, RESET A PROGRAMME BEFORE THE END
1. Press the On/Off button to switch off the appliance.
The pilot light goes out.
2. Set the programme selector on Drain.
3. Press the On/Off button to start the Drain programme.
Only open the door when the programme selector is at STOP and
the door is unlocked (after approximately 1 minute).
ENERGY AND WATER CONSUMPTION DATA
Programme Temperature
(°C)
Load
(kg)
Water
(l)
Energy
(kWh)
Programme
time
(min)
Cotton 90 4.5 69 1.75 115
Coloured Cotton 60 4.5 69 0.95 90
Synthetics 40 2.0 66 0.35 70
Delicate 40 1.5 70 0.65 55
Wool 40 1.0 70 0.55 45
GB
2

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Forenregeln

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Art des Missbrauchs:

Zum Beispiel antisemitische Inhalte, rassistische Inhalte oder Material, das zu einer Gewalttat führen könnte.

Beispielsweise eine Kreditkartennummer, persönliche Identifikationsnummer oder unveröffentlichte Privatadresse. Beachten Sie, dass E-Mail-Adressen und der vollständige Name nicht als private Informationen angesehen werden.

Forenregeln

Um zu sinnvolle Fragen zu kommen halten Sie sich bitte an folgende Spielregeln:

Neu registrieren

Registrieren auf E - Mails für Ignis awv 508 wenn:


Sie erhalten eine E-Mail, um sich für eine oder beide Optionen anzumelden.


Andere Handbücher von Ignis awv 508

Ignis awv 508 Bedienungsanleitung - Englisch - 14 seiten


Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Wenn Sie innerhalb von 15 Minuten keine E-Mail mit dem Handbuch erhalten haben, kann es sein, dass Sie eine falsche E-Mail-Adresse eingegeben haben oder dass Ihr ISP eine maximale Größe eingestellt hat, um E-Mails zu erhalten, die kleiner als die Größe des Handbuchs sind.

Ihre Frage wurde zu diesem Forum hinzugefügt

Möchten Sie eine E-Mail erhalten, wenn neue Antworten und Fragen veröffentlicht werden? Geben Sie bitte Ihre Email-Adresse ein.



Info