Bedienungsanleitung IHome IAVS1 (Seite 1 von 4) (Englisch)

695110

Zoom out

Zoom in

Vorherige Seite

1/4

Nächste Seite

FCC Information

This device complies with Part 15 of the FCC Rules, operation is subject to the following two conditions: (1) This

device may not cause harmful interference, and (2) this device must accept any interference received, including

interference that may cause undesired operation.

FCC Radiation Exposure Statement

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

• Warning: Changes or modiﬁcations to this unit not expressly approved by the party responsible for compliance could void

the user’s authority to operate the equipment.

• NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15

of the FCC Rules.

These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment o and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

CAN ICES-3 (B)/NMB-3(B)

Canada Statement

This device complies with Industry Canada’s licence-exempt RSSs. Operation is subject to the following two conditions:

(1) This device may not cause interference; and

(2) This device must accept any interference, including interference that may cause undesired operation

of the device.

Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux appareils radio exempts de licence. L’exploitation

est autorisée aux deux conditions suivantes :

(1) l’appareil ne doit pas produire de brouillage;

(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage

est susceptible d’en compromettre le fonctionnement.

The device has been evaluated to meet general RF exposure requirement.

The device can be used in portable exposure condition without restriction.

le dispositif a été évalué à satisfaire l'exigence générale de l'exposition aux rf.

l'appareil peut être utilisé dans des conditions d'exposition portatif sans restriction.

WARNING/DISPOSAL OF UNIT

Do NOT attempt to change the battery. Doing so will void the warranty and could cause injury and damage to your device.

To dispose of the unit, follow the instructions below:

• Never dispose of used batteries/electronics with ordinary solid wastes, since they contain toxic substances.

• Always dispose of used batteries/electronics in accordance with the prevailing community regulations.

• Many electronics retailers now recycle batteries and other electronic components at no charge.

GENERAL BATTERY PRECAUTIONS

• Never use or charge a battery if it appears to be leaking, discolored, deformed, or in any way abnormal.

• Never disassemble the unit or attempt to remove battery as that could cause leakage of alkaline solution or other

electrolytic substances.

• Avoid charging a rechargeable battery when the temperature is not within 5°C - 35°C (41° - 95° Fahrenheit).

• Never expose a battery to any liquid.

• Never expose a battery to excessive heat such as direct sunlight or ﬁre. Never use a battery pack in an unventilated vehicle

where excessive internal temperatures may be encountered.

• Always keep batteries out of the reach of infants and small children.

Printed in ChinaiAVS1-170420-A

Model: iAVS1

FRONT

BACK

INTERIOR

CONNECTING TO YOUR AMAZON ECHO DOT

Docking Your Amazon Echo Dot

Bedside Stereo Speaker System

Model: iAVS1

for Amazon Echo Dot

QUICK START GUIDE

» iAVS1 » USB charging cable » Universal voltage adapter » Amazon Echo Dot insert

TOP BOTTOM

Display Dimmer Button

Amazon Echo Dot Dock

Playing Amazon Echo Dot Audio

2 1

BACK

DC 12V 2A

push to open

RESET

TEST

» Connect the included USB charging cable to the Dot USB Charge Port , then pass the

other end of the cable through the slot and connect to the Echo Dot USB port.

» Connect the AC power adapter to the DC jack .

» Align the rear of the Echo Dot (the side with the USB port and Aux Jack) with the

opening in the included insert and place the two into the iAVS1 dock well with the ports

facing the back.

» Connect the built-in Aux-in cable on the back of the iAVS1 to the Aux jack of your

Echo Dot.

» You can now “Ask Alexa” to access all the functions of Echo Dot and hear the audio

through the iAVS1.

iAVS1 QSG (English)

Size: 280 x 160 mm (folded: 140 x 160 mm)

Color: print Black and

Material: 260gsm Art Card, 4C

April 20, 2017

BACK

DC 12V 2A

“Alexa, stop”

“Alexa, mute” or “Alexa, unmute”

“Alexa, set volume to 5”

“Alexa, turn up/down the volume”

For full warranty and full instructions

visit: www.ihome.com/support

VOLUME CONTROL

USING THE DIMMER BUTTON

» Use the volume control on the Amazon Echo Dot to adjust the volume to your desired

level.

» TIP: You can use Alexa voice commands to change volume or stop/pause playback.

» To dim the clock display, touch the Dimmer Button on top of the unit as needed to adjust

the display brightness through 8 levels from High to O.

» TIP: Press the + and – Buttons on iAVS1 together during clock setting to switch

display from standard 12 hour to 24 hour display.

1 Clock Setting Button

Press and hold to start

clock setting. Adjust with

+/– Buttons. Press again

to complete clock setting.

NOTE: Alexa cannot set clock

2 +/– Setting Buttons

3 Press to adjust clock

during setting (hold for

rapid adjust)

4 Backup Battery

Compartment

Unscrew door with Phillips

screwdriver. Insert 2 AAA

batteries (included) as

shown to maintain clock

setting during power

interruption.

5 Dot USB Charge Port

6 Hardwired Aux cable

7 DC Jack

Connect the included AC

adapter to the DC jack

located on the back of the

unit and connect the other

end to a working wall

8 USB Charge Device Port

Connect a standard USB cable

(not included) to charge mobile

devices.

9 Rear Cover

10 AC Adapter

Powering Amazon Echo Dot

DC 12V 2A

Amazon, Alexa, Echo Dot and all

related logos are trademarks of

Amazon.com, Inc. or its aliates.

IHome IAVS1 Anleitung

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info