Bedienungsanleitung Ikea 005.456.71 Tillreda (Seite 16 von 95) (Deutsch, Englisch, Französisch)

817519

Zoom out

Zoom in

Vorherige Seite

1/95

Nächste Seite

GB - 11

Do not fill detergent into the detergent

compartment more than required;

otherwise you can see whitish streaks

or bluish layers on glass and dishes and

may cause glass corrosion. Continued

use of too much detergent may cause

machine damage.

Using little detergent can result in

poor cleaning and you can see whitish

streaksin hard water.

See the detergent manufacturer’s

instructions for a further information.

4.9. Filling the detergent

Push the latch to open the dispenser and

pour in the detergent.

Close the lid and press it until it locks in

place. The dispenser should be refilled

just before the start of each programme.

If the dishes are heavily soiled, place

additional detergent in the pre-wash

detergent chamber.

DETERGENT

4.10. Using combined detergents

These products should be used according

to the manufacturer’s instructions.

Never put combined detergents into the

interior section or the cutlery basket.

Combined detergents contain not only

the detergent but also rinse-aid, salt

replacement substances and additional

components depending on the

combination.

We recommend you do not use

combined detergents in short

programmes. Please use powder

detergents in such programmes.

If you encounter problems when using

combined detergents, please contact the

detergent manufacturer.

When you stop using combined

detergents, make sure that water

hardness and rinse aid settings are set to

the correct level.

4.11. Rinse-aid usage

The rinse aid helps to dry the dishes

without streaks and stains. Rinse-aid is

required for stain-free utensils and clear

glasses. The rinse aid is automatically

released during the hot rinse phase. If

rinse aid dosage setting set too low,

whitish stains remains on dishes and

dishes do not dry and washed clean.

If rinse aid dosage setting set too height,

you can see bluish layers on glass and

dishes.

4.12. Filling the rinse-aid and setting

To fill the rinse aid compartment, open

the rinse-aid compartment cap. Fill the

compartment with rinse aid to the MAX

level and then close the cap. Be careful

not to overfill the rinse aid compartment

and wipe up any spills.

In order to change the rinse aid

level, follow the below steps

before turning on the machine:

•Open the door of the machine.

•Turn on the machine, and press the

Programme button as soon as the

machine is turned on.

•Hold down the Programme button

until “rA” disappears. Rinse aid setting

follows water hardness setting.

•The machine will display the last

setting.

•Change the level by pressing the

programme button.

•Turn off the machine to save the

setting.

The factory setting is “4”.

If the dishes are not drying properly or

are spotted, increase the level. If blue

stains form on your dishes, decrease the

level.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ikea 005.456.71 Tillreda Seite 16

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ikea 005.456.71 Tillreda

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info