Bedienungsanleitung Ikea HARMONISK (Seite 8 von 56) (Deutsch, Englisch, Französisch, Italienisch)

576026

Zoom out

Zoom in

Vorherige Seite

1/56

Nächste Seite

ENGLISH 8

WARNING:

- Never use steam cleaning equipment.

- Disconnect the appliance from the

power supply.

IMPORTANT:

do not use corrosive or abrasive

detergents. If any of these products accidentally

comes into contact with the appliance, clean

immediately with a damp cloth.

• Clean the surfaces with a damp cloth.

If it is very dirty, add a few drops of

washing up detergent to the water.

Finish off with a dry cloth.

IMPORTANT: do not use abrasive sponges

or metallic scrapers or scourers. Over time,

these can ruin the surface.

• Use detergents specically designed for

cleaning the appliance and follow the

manufacturer instructions.

IMPORTANT: clean the lters at least monthly

to remove any oil or grease residuals.

Perimetersuctionpanel

The suction panel must be cleaned with the

same frequency as the grease lter. Use a

damp cloth and a soft liquid detergent.

Do not use products containing abrasives.

DO NOT USE ALCOHOL

The panel normally covers the grease lters,

and must therefore be opened each time

access to the grease lters and the inside

of the hood is required (e.g. to replace the

carbon lters).

Opening: Pull the panel downwards.

Closing: The panels must be xed to the

appropriate pins on the surface of the hood.

WARNING: Always check that the panel is

tted properly.

Tocleanthegreaselter

The metal grease lter has an unlimited life

and must be washed once a month by hand

or dishwasher at low temperature and with

a short cycle. With cleaning in a dishwasher

the grease lter may become dull; this does

not effect its ltering capacity.

Greaseltermaintenance:

1. Disconnect the hood from the electric

power supply.

2 Remove the grease lters: pull the spring

release handle downwards, then remove

the lter.

3. After cleaning the grease lter, remount

in reverse order ensuring the entire

extraction surface is covered.

The front side is indicated by the writings

“Front” printed on the hidden side of the

panel.

Cleaningandmaintenance

To activate the alarm, disable the

electronic by touching the

button for

3 seconds.

Next, simultaneously touch buttons

and

for 3 seconds until hearing the

sound signal: at rst, only LED 1 will

ash and then both LEDs 1 and 2 will

ash to indicate the activation. Repeat

the procedure to deactivate the alarm:

at rst, LED 1 and 2 will ash and

subsequently only LED 1 to indicate

deactivation. If you touch simultaneously

buttons

and

for 1 second you

can verify which lter alarm mode is

activated: LED 1 ashing alone for

grease lter alarm mode, or LEDs 1 and

2 ashing for grease lter and carbon

lter alarm mode.

HIGH-SPEEDBUTTON (suction power).

INTENSIVESPEEDBUTTON (suction

power) - duration 5 minutes - touch

again to return to previous setting.

LIGHTBUTTONON/OFF

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ikea HARMONISK Seite 8

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ikea HARMONISK

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info