Bedienungsanleitung Ikea HOGKLASSIG (Seite 21 von 52) (Deutsch, Englisch)

611783

Zoom out

Zoom in

Vorherige Seite

1/52

Nächste Seite

• Loose and inappropriate plug and

socket connections can make the

terminal overheat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

• Follow the connection diagram (it is

located on the underneath surface of the

casting of the hob).

Important!

• You must observe the minimum distances

to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

• If there is no oven beneath the hob insert

a dividing panel at a minimum distance

of 20 mm from the bottom of the hob.

• Do not use silicon sealant between the

appliance and the worktop. Avoid

installing the appliance next to doors

and under windows as hot cookware

may be knocked off the rings when doors

and windows are opened.

• Only an authorized service engineer can

install, connect or repair this appliance.

Use only original spare parts.

Electrical connection

• Before connecting, check that the

nominal voltage of the appliance stated

on the rating plate, corresponds to the

available supply voltage. Also, check the

power rating of the appliance and

ensure that the wire is suitably sized to

suit the appliance power rating (refer to

the "Technical information" chapter). The

rating plate is located on the lower

casing of the hob.

• The appliance is not provided with a

mains cable. Buy the right one from

specialized dealer. Single phase or two-

phase connection requires a mains cable

of minimum 90°C temperature stability.

Cable has been provided with end

sleeves. According to IEC regulations use

for one-phase connection: mains cable 3

x 4mm² and for two-phase connection:

mains cable 4 x 2.5mm². Please respect

in first priority specific national

regulations.

• The appliance works perfectly on AC

230 V, AC 220 V~ or AC 240 V~ 50 Hz

electrical network.

• You must have the means for

disconnection incorporated in the fixed

wiring. Have the appliance connected to

the mains using a device that allows the

appliance to be disconnected from the

mains at all poles with a contact opening

width of at least 3 mm, eg. automatic line

protecting cut-out, earth leakage trips or

fuse.

• You must have the connection and the

connecting links carried out as shown in

the connection diagram (it is located on

the underneath surface of the casing of

the hob). The earth lead is connected to

terminal marked with the symbol and

must be longer than leads carrying

electric current. Tighten the terminal

screws securely! Finally, secure the

connecting cable with the mains cable

cleat and the covering closed by

pressing firmly (lock into place).

Warning! Once connected to the

mains supply check that all

cooking zones are ready for use

by briefly setting each to

maximum power.

ENGLISH 21

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ikea HOGKLASSIG Seite 21

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ikea HOGKLASSIG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info