Bedienungsanleitung Ikea MOJLIG (Seite 9 von 28) (Englisch, Holländisch)

507166

Zoom out

Zoom in

Vorherige Seite

1/28

Nächste Seite

Ensure that the local distribution condi-

tions (nature of the gas and gas pres-

sure) and the adjustment of the appliance

are compatible before proceeding with the

installation.

The parameters of adjustment setting

for this appliance are stated on the

rating plate (refer to the Technical data

chapter).

Warning! The appliance must be

earthed!

Warning! Risk of injury from electrical

current.

• The electrical mains terminal is live.

• Make electrical mains terminal free of

voltage.

• Loose and inappropriate plug and socket

connections can make the terminal over-

heat.

• Have the clamping connections correctly

installed.

• Use strain relief clamp on cable.

Important! You must observe the minimum

distances to other appliances and furniture

cabinets or other units according to

Assembly Instruction.

The minimum distance to be maintained

from the cut out edge to lateral wall must

be 450 mm.

If there is no oven beneath the hob insert a

dividing panel at a minimum distance of 20

mm from the bottom of the hob.

Protect the cut surfaces of the worktop

against moisture using a suitable sealant in-

cluded in the product in fitting bag. The

sealant seals the appliance to the work top

with no gap. Do not use silicon sealant be-

tween the appliance and the worktop.

Avoid installing the appliance next to doors

and under windows as hot cookware may

be knocked off the pan support when doors

and windows are opened.

Gas Connection

Warning! This appliance is not

connected to a combustion products

evacuation device.

Installation must comply with current local

regulation.

The connection of the cooktop to the gas

pipe network or gas cylinder must be made

by means of a rigid copper or steel pipe

with fittings complying with local regula-

tions, or by means of a continuous surface

stainless steel hose complying with local

regulations.

If you see any abnormalities do not re-

pair the pipe, contact local After Sales

Service (refer to the Service chapter).

The connection must be installed correctly,

fixed into hob connection pipe. Otherwise it

will cause leakage of gas

Warning! Once the installation is

complete, check the perfect seal of

every pipe fixing. Use soapy water, never

flame.

Electrical connection

The electrical work necessary to install the

appliance must be done by a qualified

electrician or competent person, according

to the current regulations.

Before connecting, check that the nominal

voltage of the appliance stated on the rat-

ing plate, corresponds to the available sup-

ply voltage. Also, check the power rating of

the appliance and ensure that the wire is

suitably sized to suit the appliance power

rating (refer to the Technical data chapter).

The rating plate is located on the lower cas-

ing of the hob.

The appliance is supplied with a connection

cable. This has to be provided with a prop-

er plug, able to support the load marked on

the identification plate (refer to the Techni-

cal data chapter).

ENGLISH 9

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ikea MOJLIG Seite 9

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ikea MOJLIG

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info