Bedienungsanleitung Ikea TINAD (Seite 6 von 68) (Deutsch, Englisch, Französisch, Italienisch)

676179

Zoom out

Zoom in

Vorherige Seite

1/68

Nächste Seite

ENGLISH 6

Keep children away from the installation site.

After unpacking the appliance, make sure that

it has not been damaged during transport.

In the event of problems, contact the dealer

or your nearest Aftersales Service. Once

installed, packaging waste (plastic, styrofoam

parts etc.) must be stored out of reach of

children - risk of suffocation. The appliance

must be disconnected from the power supply

before any installation operation - risk of

electrical shock. During installation, make sure

the appliance does not damage the power

cable - risk of re or electrical shock. Only

activate the appliance when the installation

has been completed.

Be careful not to damage the oors (e.g.

parquet) when moving the appliance.

Install the appliance on a oor or support

strong enough to take its weight and in a

placesuitable for its size and use. Make sure

the appliance is not near a heat source and

that the four feet are stable and resting on the

oor, adjusting them as required, and check

that the appliance is perfectly level using a

spirit level. Wait at least two hours before

switching the appliance on, to ensure that the

refrigerant circuit is fully efcient.

WARNING: To avoid a hazard

due to instability, positioning

or xing of the appliance must

be done in accordance with the

manufacturer instructions.

Warning: It’s forbidden to place the

refrigerator in such way that the metal hose

of gas stove, metal gas or water pipes,

or electrical wires are in contact with the

refrigerator back wall (condenser coil).

ELECTRICAL WARNINGS

It must be possible to

disconnect the appliance from the

power supply by unplugging it if

plug is accessible, or by a multi-

pole switch installed upstream

of the socket and the appliance

must be earthed, in conformity

with national electrical safety

standards.

Do not use extension leads, multiple

sockets or adapters. The electrical components

must not be accessible to the user after

installation. Do not use the appliance when

you are wet or barefoot. Do not operate this

appliance if it has a damaged power cable

or plug, if it is not working properly, or if it

has been damaged or dropped. If the power

cable is damaged, it must be replaced with an

identical one - risk of electrical shock.

If the supply cord is damaged,

it must be replaced with an

identical one by the manufacturer,

its service agent or similarly

qualied persons in order to avoid

a hazard - risk of electrical shock.

Make sure the voltage

specied on the rating plate

corresponds to that of your home.

Do not store explosive

substances such as aerosol cans

with a ammable propellant in this

appliance.

Do not store or use petrol, ammable

liquids or gas in the vicinity of this or other

electrical appliances. The fumes can cause

res or explosions.

Feets of the product: in Fs not

available;in built in - the “feet are

not adjustable - and the METOD

cabinet should be levelled with

spririt level.

Do not pull the appliance

power cable.

Missbrauch melden von Frage und/oder Antwort

Libble nimmt den Missbrauch seiner Dienste sehr ernst. Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln. Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen. Wir melden uns nur dann wieder bei Ihnen, wenn wir weitere Einzelheiten wissen müssen oder weitere Informationen für Sie haben.

Ikea TINAD Seite 6

Brauchen Sie Hilfe? Stellen Sie Ihre Frage.

Missbrauch melden von Frage und/oder Antwort

Art des Missbrauchs:

Forenregeln

Neu registrieren

Andere Handbücher von Ikea TINAD

Das Handbuch wird per E-Mail gesendet. Überprüfen Sie ihre E-Mail.

Ihre Frage wurde zu diesem Forum hinzugefügt

Info